Kodak 8942930 manual Regulatory compliance and advisory, Outside the United States and Canada

Page 24

Appendix

Outside the United States and Canada

In countries other than the United States and Canada, the terms and conditions of this warranty may be different. Unless a specific Kodak warranty is communicated to the purchaser in writing by a Kodak company, no warranty or liability exists beyond any minimum requirements imposed by law, even though defect, damage, or loss may be by negligence or other act.

Regulatory compliance and advisory

FCC compliance and advisory

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. The equipment generates, uses, and can radiate radio frequency energy and, if not installed or used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1) reorient or relocate the receiving antenna; 2) increase the separation between the equipment and the receiver; 3) connect the equipment to an outlet on a circuit different from that to which the receiver is connected; 4) consult the dealer or an experienced radio/TV technician for additional suggestions. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Where shielded interface cables have been provided with the product or specified additional components or accessories elsewhere defined to be used with the installation of the product, they must be used in order to ensure compliance with FCC regulation.

19

www.kodak.com/go/support

Image 24
Contents Kodak Easyshare Digital Frame Eastman Kodak Company Rochester, New York Top-buttons and controls Side-power and connectors Table of contents Attaching the power cable Getting startedAttaching the stand Turning your frame on and offConnecting a USB device Inserting a memory cardViewing pictures from internal memory Viewing pictures from a memory cardSetting automatic shut-off time Navigating through your picturesNavigation and play buttons Changing play speed, transitions, and order Play speed and transitionPlay order Doing more with your frame Deleting pictures from the frameCopying pictures to internal memory Example from SD card to internal memoryUpgrade your frame Upgrading your firmware recommendedCheck your frame’s current firmware version Download the latest firmwareMaintaining your frame Picture frame problems Learning more about your frameTry one or more of the following Troubleshooting and support Identifying graphic messages Graphic DescriptionIdentifying error messages Digital frame specifications Important safety instructions Kodak Easyshare P725/P825 Digital FramesAdditional care and maintenance Limited warrantyLimited warranty coverage Limitations Your rightsRegulatory compliance and advisory Outside the United States and CanadaFCC compliance and advisory Canadian DOC statement LicensingAustralian C-Tick Waste Electrical and Electronic Equipment labelingRussian GOST-R Vcci Class B ITE Korean Class B ITEChina RoHS Energy Star Product Index USB