Powermatic 719T Assembly, Securing Machine to Stand, Wooden Table, Operating Handle

Page 10

Assembly

Do not connect the machine to power source until completely assembled. Read and understand the entire manual.

Securing Machine to Stand

The mortiser should be secured to the stand with four M8 x 45 hex cap screws and M8 lock washers (provided) using the holes in the base. Make sure there is enough room on each side of the mortiser for the size stock you plan to use.

Wooden Table

Referring to Figure 6:

1.Place the wooden table (A) in position on the slide (B).

2.Secure with two Phillips head screws provided (C).

Operating Handle

Referring to Figure 7:

1.Fasten operating handle (A) to the hub (B) and tighten with a 14mm open-end wrench.

2.Raise mortising machine head to the up position by moving the operating handle

(A) up.

Note: The handle assembly is spring-loaded and can be repositioned by pulling out the hub (B) and repositioning it on the pinion shaft (C).

Figure 6

Figure 7

10

Image 10

Contents Powermatic Part No. M-2474002Warranty and Service Warranty PeriodTable of Contents Page Page Introduction Specifications Contents of the Stand Carton Contents of the Mortiser CartonUnpacking Electrical Connections Grounding InstructionsExtension Cords Converting from 115 to 230 VoltRecommended Minimum Gauge AWG of Extension Cords Wooden Table AssemblySecuring Machine to Stand Operating HandleInstalling Chisel and Bit Work StopStart/Stop Switch On-Off Switch PadlockOperating Controls Chisel to Worktable Calibration AdjustmentsChuck Extension Adaptor Forward/Backward Table Movement Depth Stop Rod AdjustmentTable Position Lateral Table MovementOperation Chisel Parallel to WorkpieceSharpening Chisel and Bit MaintenanceGeneral BitLubrication Optional AccessoriesReplacement Parts Storage719T Mortiser Assembly 719T Mortiser Parts List Index No. Part No Description Size Qty719T-156 113 TS-1540061 719T Mortiser Stand Parts List 719T Mortiser Stand AssemblyOptional Accessories Index No. Part No DescriptionDimensions for 719T with premium chisels mounted Chisels and bits purchased separately