Boss Audio Systems GT 1480, GT 1580, GT 1380, GT 1180 specifications Systems

Page 4
CHANNEL 3 (+)
CHANNEL 3 (-)
CHASSIS GROUND CHANNEL 4 (-) CHANNEL 4 (+)

Electrical Wiring

All BOSS GT series power amplifiers are equipped with easy top access screw terminals. These terminals are nickel-plated in order to ensure excellent electrical contact and resist corrosion.

When making electrical connections to the amplifier, please observe the following:

Use at least 8 gauge or heavier wire for power and ground connections.

Wire the amplifier directly to the car battery. Make sure there is circuit protection (such as a fuse) on the positive power lead, within 18 inches of the battery.

For the ground connection, use the shortest possible wire to a good chassis ground point.

Wire the Remote connection to the remote turn-on lead of your equalizer or head unit. In some cases cases this may be the power antenna lead of the head unit.

Remote Subwoofer Level Control

All BOSS GT series power amplifiers are equipped with a dashboard mount remote subwoofer

6 level control. Run the supplied dashboard remote control from the front panel of your amplifier. By turning the level knob clockwise, you will increase the output of low frequencies.

Fuses

Fuses protect both the amplifier and the electrical system of your vehicle from faulty conditions. If you must replace the fuse in your GT amplifier, use a fuse of exactly the same type and rating. A different type or rating may result in damage or cause a fire.

Mounting the Amplifier

Mark the location for the mounting screw holes by positioning the amplifier where you wish to install it and use a scribe (or one of the mounting screws) inserted in each mounting hole to mark the mounting surface. If the mounting surface is carpeted, measure the hole centers and mark with a felt tip pen.

Drill pilot holes in the mounting surface for the mounting screws and insert the mounting screws into these holes. Tighten them securely.

High Level Inputs

The GT 4-Channel amplifiers utilize a separate connector for Channels 1/2 and Channels 3/4.

WARNING: If you use the HIGH LEVEL (speaker) inputs, do not use the LOW LEVEL inputs at the same time.

 

 

 

AUDIO

 

Four Channel Amplifiers:

 

SYSTEMS

 

GT 1180, GT 1380, GT 1480

 

 

 

CHANNEL 2 (+)

7

 

CHANNEL 2 (-)

 

 

CHASSIS GROUND

 

 

CHANNEL 1 (-)

 

 

CHANNEL 1 (+)

 

 

 

 

HEAD UNIT

From

HEAD UNIT

SPEAKER

OUTPUTS

Note: Before beginning your installation, be sure to take note of any wires, lines or other devices in your vehicle which may be located behind any mounting surface.

Image 4
Contents Audio Audio ModelA T U R E S Systems Mode Switch Settings Fi ve Channel a mpl i f i er Mode Switch 4ch PositionHigh Level Inputs 5 Channel Amplifier GT Four Channel Amplifiers GT1180, GT1380, GT148Four Channel Speaker Wiring Bridged Speaker WiringFour Channel Amplifiers GT 1180, GT 1380, GT1480 Component ValuesFive Channel Amplifier Five Channel Speaker WiringFive Channel Amplifiers Precautions