Cleaning, Special notes on Smart All-in- One

1. For your safety

•The SMART All-in-One is equipped with a three-pronged grounded plug, a plug with a third (grounding) pin.This plug will fit only into a grounded power outlet as a safety feature. If your outlet does not accommodate the three-wire plug, have an electrician install the correct outlet, or use an adapter to ground the appliance safely. Do not defeat the safety purpose of the grounded plug.

•Unplug the unit during a lightening storm or when it will not be used for long period of time.This will protect the SMART All-in- One from damage due to power surges.

•Do not overload power strips and extension cords. Overloading can result in fire or electric shock.

•Never push any object into the slot on the SMART All-in-One cabinet. It could short circuit parts causing a fire or electric shock. Never spill liquids on the SMART All-in- One.

•Do not attempt to service the SMART All- in-One by yourself; opening or removing covers can expose you to dangerous voltages and other hazards. Please refer all servicing to qualified service personnel.

•To ensure satisfactory operation, use the SMART All-in-One only with UL listed computers which have appropriate configured receptacles marked between 100 - 240V AC, Min. 5A.

•The wall socket shall be installed near the equipment and shall be easily accessible.

•For use only with the attached power adapter (Output 19V DC) which have UL, CSA listed licensed (only for monitor with power adapter).

Model: ADPC1965

Manufacturer: TPV ELECTRONICS (FUJIAN) CO., LTD.

Model: ADS-65LSI-19-1 19065G

Manufacturer: SHENZHZEN HONOR ELECTRONIC CO., LTD.

1.2 Cleaning

•Clean the cabinet regularly with cloth.You can use soft-detergent to wipe out the stain, instead of strong-detergent which will cauterize the product cabinet.

•When cleaning, make sure no detergent is leaked into the product.The cleaning cloth should not be too rough as it will scratch the screen surface.

•Please disconnect the power cord before cleaning the product.

1.3Special notes on SMART All-in- One

The following symptoms are normal with SMART All-in-One and do not indicate a problem.

Note

•Due to the nature of the fluorescent light, the screen may flicker during initial use.Turn off the Power Switch and then turn it on again to make sure the flicker disappears.

•You may find slightly uneven brightness on the screen depending on the desktop pattern you use.

•The LCD screen has effective pixels of 99.99% or more. It may include blemishes of 0.01% or less such as a missing pixel or a pixel lit all of the time.

•Due to the nature of the LCD screen, an afterimage of the previous screen may remain after switching the image when the same image has been displayed for a long time.The SMART All-in-One will slowly recover from this.

•When the screen becomes black or flashing, or cannot illuminate any more, contact your dealer or service center to replace parts. Don’t repair the screen by yourself!