9 Troubleshooting
This section describes commonly encountered issues and accompanying solutions.
TV channel issues
Previously installed channels do not appear in the channel list:
Check that the correct channel list is selected.
English
General TV issues
The TV does not switch on:
Disconnect the power cable from the power outlet. Wait for one minute then reconnect it.
Check that the power cable is securely connected.
The remote control is not working properly: Check that the remote control batteries are correctly inserted according to the +/- orientation.
Replace the remote control batteries if
Clean the remote control and TV sensor lens.
The standby light on the TV blinks red: Disconnect the power cable from the power outlet. Wait until the TV cools down before reconnecting the power cable. If the blinking reoccurs, contact Philips Consumer Care.
You forgot the code to unlock the child lock feature
The TV menu is in the wrong language. Change the TV menu to your preferred language.
When turning the TV on/off/to standby, you hear a creaking sound from the TV chassis:
No action is required. The creaking sound is normal expansion and contraction of the TV as it cools down and warms up. This does not impact performance.
Picture issues
The TV is on, but there is no picture: Check that the antenna is properly connected to the TV.
Check that the correct device is selected as the TV source.
There is sound but no picture:
Check that the picture settings are correctly set.
There is poor TV reception from an antenna connection:
Check that the antenna is properly connected to the TV.
Loudspeakers, unearthed audio devices, neon lights, high buildings and other large
If possible, try to improve the reception quality by changing the antenna direction or moving devices away from the TV.
If reception on only one channel is poor,
There is poor picture quality from connected devices:
Check that the devices are connected properly.
Check that the picture settings are correctly set.
The TV did not save your picture settings: Check that the TV location is set to the
home setting. This mode offers you the
big or too small:
Try using a different picture format. The picture position is incorrect:
Picture signals from some devices may
signal output of the device.
EN 29
Downloaded From