Philips CID3687/00 user manual Get started, Install the car audio, Connect wires

Page 8

3 Get started

Caution

Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation.

Always follow the instructions in this chapter in sequence.

Install the car audio

These instructions are for a typical installation. However, if your car has different requirements, make the corresponding adjustment. If you have any questions regarding installation kits, consult your Philips car audio dealer.

Caution

This unit is designed for negative ground (earth) 12 V DC operation only.

Always install this unit in the car dashboard. Other locations can be dangerous as the rear of the unit heats up during use.

To avoid short-circuit: before you connect, ensure that the ignition is off.

Ensure that you connect the yellow and red power supply leads after all other leads are connected.

Ensure that all loose leads are insulated with electrical tape.

Ensure that the leads do not get caught under screws orin parts that will move (e.g. seat rail).

Ensure that all ground (earth) leads are run to a common ground (earth) point.

Use only the supplied mounting hardware for a safe and secure installation.

Improper fuses can cause damage or fire. When you need to change the fuse, consult a professional.

Note on the power supply lead (yellow)

When you connect other devices to this system, ensure that the rating of the car circuit is higher than the total fuse value of all the connected devices.

Notes on speaker connection

Never connect speaker wires to the metal body or chassis of the car.

Never connect speaker wires with stripes to one another.

Connect wires

Caution

Ensure that all loose leads are insulated with electrical tape.

8EN

Image 8
Contents ZH-HK ZH-CN Page Contents Environmental information SafetyRecycling English Introduction Check and identify the contents of your packageWhat’s in the box Overview of the main unit Install the car audio Connect wiresNever connect speaker wires with stripes to one another Get startedConnect GPS antenna Connect radio antennaMount in the dashboard Reconnect the negative terminal of the car battery Turn onSet date and time Press and hold /MUTE/VOL to turn on the unitUpgrade the map Use mapSet time Tap Time Tap or to set hour and minuteTune by frequency Listen to radioTune to a radio station Play with RDS Optional Tune to a preset stationStore radio stations in memory Select program type Select alternate frequenciesTurn on RDS EONRDS TA VOLPlay Load discsConnect USB device Remove the USB deviceInsert USB or SD/MMC card Play/PauseSkip/search Remove the SD/MMC cardRepeat a section Search within a title/folderRepeat Select audio mode Random playSelect audio language Select subtitle languageSelect slide show duration Play with BluetoothDevice Disconnect Bluetooth devices Switch phone call to the mobileMake a call Receive callDuring talking, tap Listen to music from Bluetooth deviceAdjust Bluetooth settings Adjust sound Adjust volumeSelect preset equalizer Adjust fader/balanceAdjust settings Adjust general settingsTap F, R, L, or R to adjust fader/balance value Set Dynamic Bass Boost DBBAdjust sound settings OirtAdjust video settings Adjust language settings Adjust volume settingsPairing View code for Code Other BluetoothOthers English Listen to other devices Adjust DVD ratingReset Remove the unit Replace fuseAM MW LCD Product informationAmmw Divx Home theater MP4 Xvid TroubleshootingDVD About Bluetooth device Image flashes or distortedDevice cannot be used with the system to play music Paired mobile phone connects and disconnects constantlyGlossary MMCMP3 Sdhc