English
Install the car audio
These instructions are for a typical installation. However, if your car has different requirements, make the corresponding adjustment. If you have any questions regarding installation kits, consult your Philips car audio dealer.
Caution
This unit is designed for negative ground (earth) 12 V DC operation only.
Always install this unit in the car dashboard. Other locations can be dangerous as the rear of the unit heats up during use.
To avoid
Ensure that you connect the yellow and red power supply leads after all other leads are connected.
Ensure that all loose leads are insulated with electrical tape.
Ensure that the leads do not get caught under screws orin parts that will move (e.g. seat rail).
Ensure that all ground (earth) leads are run to a common ground (earth) point.
Use only the supplied mounting hardware for a safe and secure installation.
,PSURSHUIXVHVFDQFDXVHGDPDJHRUÀUH
When you need to change the fuse, consult a professional.
Connect wires 1
Caution
Ensure that all loose leads are insulated with electrical tape.
1Check the car’s wiring carefully, then connect them to the two supplied ISO wires. a
Connector Connect to
1Brown wire Telephone mute
2Red wire The +12V power terminal which is live in the accessory (ACC) position of the ignition switch
If there is no accessory position, connect to the +12V car battery terminal that is always live. Be sure to connect the black ground (earth) lead to a metal surface
RIWKHFDUÀUVW
3Orange wire Illumination switch
4Black wire A metal surface of the car First connect the black ground (earth) lead, then connect the yellow and red power supply leads.
5Yellow wire The +12V car battery which is live at all times.
6Blue wire The electric antenna control lead or power supply lead of the antenna booster
If there is no electric antenna or antenna booster, or it is manually operated telescopic antenna, it is not necessary to connect this lead.
7Green and Left speaker (Rear) green/black
wires
8White and Left speaker (Front) white/black
wires
9Gray and Right speaker (Front) gray/black
wires
10 Purple and Right speaker (Rear) purple/black
wires
2Connect the other end of the two ISO connectors to the car audio system. b
3If necessary, do the other connections: c