3 |
English
Connect wires: ISO connectors
navigation computer, the computer may |
lost its memory. |
• If the car battery is not disconnected, |
to avoid |
wires do not touch each other. |
Set clock
1 Touch
to display main menu.
2 Touch [Setting].
»The setup menu is displayed.
2 Insert the USB device or SD/MMC card into the USB socket or SD/MMC card slot.
»Play starts automatically.
an |
|
| P |
|
| r | |
| niP | ||
a | ihC ni gnit ir | ||
ni | tn |
| |
| hC ni gni |
|
|
1 | Pull out the ISO connectors from the car | |
| dashboard and connect them to the bigger | |
| end of the supplied standard connector. | |
2 | Connect the other end of supplied standard | |
| connector to the unit. | |
| • If necessary, connect the following: | |
|
|
|
| Connector | Connect to/with |
1 | Black cable | Antenna |
2 | Yellow cable | Video out 1 |
3 | Yellow cable | Video out 2 |
2 | Ensure that car dashboard opening is within |
| these measurements: |
| • Since the unit cannot be used if the |
| dashboard opening’s slant angle is above |
| 20 degrees: Ensure that the horizontal |
| slant of the car dashboard opening is |
3 | between 0 and 20 degrees |
Remove the screws on the both side of the | |
| unit. |
4 | Remove the mounting sleeve. |
5 | Install the sleeve into the dashboard and |
| bend the tabs outward to fix the sleeve. |
3 | Touch [General]. |
|
|
|
|
|
|
|
|
|
|
|
|
| Pair the |
| |||||
4 | Touch the [Clock mode] repeatedly to | devices | |||||||||||||||||||
| select: |
|
|
|
|
|
|
|
|
|
|
|
|
| 1 | Turn on the Bluetooth function on the | |||||
| • | [12hr] : 12 hour mode |
|
|
|
|
|
|
|
|
|
|
|
|
| ||||||
5 | • | [24hr] : 24 hour mode |
|
|
|
|
|
|
|
|
|
|
|
|
| 2 | device. | ||||
Touch the hour digits, then touch |
|
|
|
|
|
| or |
|
| . |
|
| Setup the Bluetooth function on your device. | ||||||||
6 | Touch the minute digits, then touch |
|
|
|
|
|
| or |
|
| . | 3 | Select “CED750” in the pairing list. | ||||||||
7 | If 12 hour mode is selected, touch |
|
|
|
|
|
| or |
|
| 4 | Enter default password “0000”. | |||||||||
| to select AM or PM. |
|
|
|
|
|
|
|
|
|
|
|
|
|
| » iI pairing succeeds. [Connect] is displayed | |||||
8 | Touch to exit. |
|
|
|
|
|
|
|
|
|
|
|
|
|
| on the panel. | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||||||
4 |
4 | Yellow cable | Camera in |
5 | Green/white | Parking |
| wire |
|
6 | Black cable | Bluetooth microphone |
7 | Blue cable | Subwoofer |
|
|
|
8 | Red cable | Front line out L |
9White cable Front line out R
0 | Red cable | Rear line out L |
! | white cable | Rear line out R |
|
|
|
6 | Place the rubber cushion over the end of the |
| bolt. |
7 | Slide the unit into the dashboard until a click |
| sound is heard. |
| • If the unit cannot fit into the dashboard, |
| remove the mounting bracket on the |
| both side of the unit and replace them |
| with the supplied short mounting |
8 | brackets. |
Attach the trim plate. | |
9 | Reconnect the negative terminal of the car |
| battery. |
Tune to a radio station
1 Touch 
to display the main menu.
2 Touch [Radio].
»Band and frequency information is displayed.
3 Touch [Band] repeatedly to select:
•FM band options: FM1, FM2, FM3
•AM band options: AM1, AM2
4 Briefly touch [Previous] or [Next] to tune to a radio station by step.
Make a call
1 Pair the phone with the system.
2 Touch
to return to main menu.
3 Touch [Bluetooth].
»The Bluetooth menu is displayed.
4 Touch
to dial.
Receive call
1 If there is incoming call, [Incoming call…]
Mount in the dashboard 
Note
•Check wire connection before you mount the unit into a car.
•If preset radio stations are lost when the ignition key is turned OFF and then back ON, reconnect the red leads crosswise to the yellow ones.
Turn on
1 Press the 
to turn on the unit.
»The screen opens automatically.
»The available OSD
2 Touch a language to select.
| » The OSD language is changed to the |
| selected language immediately. |
• | To adjust the screen tilt, press TILT . |
• | To close the screen, press OPEN/CLOSE. |
Play discs 
1 Insert the disc into the disc slot with label side facing up.
»Play starts automatically.
»To remove the disc, press the 
button.
»When the disc is ejected, the unit switches to the previous source, if connected. Other- wise, the unit switches to [Radio] mode auto- matically.
flashes on the screen. Speak into the Blue- tooth microphone.
2 When conversation ends, touch
to terminate the call.
1 | If the car does not have an |
| navigation computer, disconnect the negative |
terminal of the car battery.
• If you disconnect the car battery in a car that has an
• | To adjust the brightness/contrast, press / , | ||
| then adjust 4 WAY NAVIGATION. | ||
• | To turn off the system, press |
| for 3 sec- |
| |||
| |||
| onds. | ||
| » The screen closes automatically. | ||
Insert USB or SD/MMC card
1 | Open the USB/SD/MMC card cover. | © 2008 Koninklijke Philips Electronics N.V. |
|
All rights reserved.