Philips CEM3100 Get started, Install the car audio, Connection for cars with ISO connectors

Page 9

3 Get started

Caution

•• Use the controls only as stated in this user manual.

Always follow the instructions in this chapter in sequence.

If you contact Philips, you will be asked for the model and serial number of your apparatus.The model number and serial number are on the bottom of your apparatus. Write the numbers here:

Model No. __________________________

Serial No. ___________________________

Install the car audio

These instructions are for a typical installation. However, if your car has different requirements, make the corresponding adjustment. If you have any questions regarding installation kits, consult your Philips car audio dealer.

Caution

•• This unit is designed for negative ground (earth) 12 V DC operation only.

•• Always install this unit in the car dashboard. Other locations can be dangerous as the rear of the unit heats up during use.

•• To avoid short-circuit: before you connect, ensure that the ignition is off.

•• Ensure that you connect the yellow and red power supply leads after all other leads are connected.

•• Ensure that all loose leads are insulated with electrical tape.

•• Ensure that the leads do not get caught under screws orin parts that will move (e.g. seat rail).

•• Ensure that all ground (earth) leads are run to a common ground (earth) point.

•• Use only the supplied mounting hardware for a safe and secure installation.

•• Improper fuses can cause damage or fire. When you need to change the fuse, consult a professional.

Note on the power supply lead (yellow)

•When you connect other devices to this apparatus, ensure that the rating of the car

circuit is higher than the total fuse value of all the connected devices.

Notes on speaker connection

•Never connect speaker wires to the metal body or chassis of the car.

•Never connect speaker wires with stripes to one another.

Connection: for cars with ISO connectors

Caution

•• Ensure that all loose leads are insulated with electrical tape.

Note

•• Consult a professional to connect CEM3100 as instructed below.

•• The ISO male connectors are not supplied.

1Connect the male connector to the unit.

2Check the car's wiring carefully and connect them to the the male connector.

Note

•• Risk of danger! Please consult a professional to perform the below steps!

EN 7

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Register your product and get support at Always there to help youPage Contents Recycling SafetyNever place any objects other than discs into the apparatus Environmental informationKoninklijke Philips Electronics N.V. All rights reserved Your car audio system IntroductionWhats in the box Source Overview of the main unitSelect audio source Display LCD color MenuOverview of the remote control Connection for cars with ISO connectors Install the car audioConnect the male connector to the unit Get startedMount into the dashboard 5mm Turn on Install remote control batterySet clock Attach the front panelTune to a radio station Listen to radioView clock Select tuner regionTune to a preset station Store radio stations in memoryPlay with RDS Receive traffic announcement Select alternate frequenciesPlay a disc Play audio filesSet RDS clock CT OFF turn off the RDS clockPlay from iPod/iPhone Play from USBPlay options Adjust sound Switch music listening zone Select preset equalizerOther sound settings Turn on/off full soundTurn demo mode on/off Select blackout settingTurn beep sound on/off DimmerRotate to select a setting Fast Slow ResetLCD Color AudiobookDetach the front panel Additional informationReplace fuse Remove the unitProduct information AmmwFAT32 Troubleshooting Glossary MP3WMA Windows Media Audio Page All rights reserved CEM310012UMV3.0
Top Page Image Contents