3 Before use
Caution
•• Use the controls only as stated in this user manual.
Always follow the instructions in this chapter in sequence.
If you contact Philips, you will be asked for the model number and serial number of your car audio system.The model number and serial number are on its bottom.Write the numbers here:
Model No.: __________________________
Serial No.: ___________________________
Install the car audio system
These instructions are for a typical installation. However, if your car has different requirements, make the adjustment accordingly. If you have any question regarding installation kits, consult your local retailer.
Caution
•• This system is designed for negative ground (earth) 12V DC operation only.
•• Always install this system in the car dashboard. Other locations can be dangerous as the rear of the system heats up during use.
•• To avoid
•• Make sure that you connect the yellow and red power supply leads after all other leads are connected.
•• Make sure that all loose leads are insulated with electrical tape.
•• Make sure that the leads do not get caught under screws iron parts that will move (e.g. seat rail).
•• Make sure that all ground (earth) leads are run to a common ground (earth) point.
•• Use only the supplied mounting hardware for a safe and secure installation.
•• Improper fuses can cause damage or fire. When you need to change the fuse, consult a professional.
•• When you connect other devices to this system, make sure that the rating of the car circuit is higher than the total fuse value of all the connected devices.
•• Never connect speaker wires to the metal body or chassis of the car.
•• Never connect speaker wires with stripes to one another.
Connect wires
Caution
•• Make sure that all loose leads are insulated with electrical tape.
1 Check the car's wiring carefully, and then connect them to the supplied ISO wires.
h
a
b
g c
d 
f
| e |
Connector | Connect to |
1 Yellow | The +12V car battery which is |
wire | live at all times |
2 Blue/White The electric antenna control
wire lead or power supply lead of the antenna booster. If there is no electric antenna or antenna booster, or it is manually operated telescopic antenna, it is unnecessary to connect this lead.
3 Black wire A metal surface of the car. Connect the black ground (earth) lead before connecting the yellow and red power supply leads.
E n g l i s h
EN 9