Philips CEM200 user manual Mount in the dashboard, Tip

Page 11

Tip

‡The pin arrangement for the ISO connectors depends on the type of vehicle you drive. Make sure to make the proper connections to prevent damage to the unit.

Mount in the dashboard

1If the car does not have an on-board drive or navigation computer, disconnect the negative terminal of the car battery. ‡ If you disconnect the car battery in

a car that has an on-board drive or navigation computer, the computer may lose its memory.

‡ If the car battery is not disconnected, to avoid short-circuit, ensure that bare wires do not touch each other.

2Remove the two screws on the top of the unit.

3Remove the mounting sleeve with the supplied disassembly tools.

4Ensure that car dashboard opening is within these measurements:

 

5mm

1

 

83

mm

 

 

53mm

5Install the sleeve into the dashboard and

EHQGWKHWDEVRXWZDUGWRÀ[WKHVOHHYH

Note

‡6NLSWKLVVWHSLIWKHXQLWLVQRWÀ[HGE\VOHHYH but by supplied screws.

12EN

Image 11
Contents Register your product and get support at CEM200 Contents Safety Environmental information RecyclingWhat’s in the box Your car audio systemIntroduction ‡ &RQÀUPVHOHFWLRQ Overview of the main unitOverview of the remote control &RQÀUPVHOHFWLRQ Install the car audio Get started Overview of parts Connection for cars with ISO connectorsConnection for cars without ISO connectors Tip Mount in the dashboardRUÀUVWWLPHXVH Install remote control batteryAttach the front panel Tune to a radio station Listen to radioTurn on Set clockPlay a disc Tune to a preset stationPlay audio files Store radio stations in memoryIntro play Control playSearch for an MP3/WMA track View play informationAdjust sound Turn beep sound on/off Turn demo mode on/offSelect start volume Store preset volumeDetach the front panel Select shock-protect settingReset Remove the unit Replace fuse‡ QVXUHWKDWWKH&LVDÀQDOLVHG&& CD-RW TroubleshootingMP3 GlossaryPage Page
Related manuals
Manual 25 pages 46.64 Kb