Dual XDVD8182 owner manual Safety Information, To prevent damage or injury, Additional Notes

Page 5

XDVD8182 OPERATION

Safety Information

Please read all instructions carefully before attempting to install or operate.

Due to its technical nature, it is highly recommended that your DUAL XDVD8182 is installed by a professional installer or an authorized dealer. This product is only for use in vehicles with 12VDC negative ground only.

Safety Notes:

The DVD video display of the in-dash unit will not operate while the vehicle is moving. This is a safety feature to prevent driver distraction. In-dash DVD video functions will only operate when vehicle is in Park and the parking brake is engaged. It is illegal in most states for the driver to view video while the vehicle is in motion.

To prevent damage or injury:

1.Make sure to ground the unit securely to the vehicle chassis ground.

2.Do not remove the top or bottom covers of the unit.

3.Do not install the unit in a spot exposed to direct sunlight or excessive heat or the possibility of water splashing.

4.Do not subject the unit to excessive shock.

5.When replacing a fuse, only use a new one with the prescribed rating. Using a fuse with the wrong rating may cause the unit to malfunction.

6.To prevent short circuits when replacing a fuse, disconnect the wiring harness first.

7.Use only the provided hardware and wire harness.

8.You cannot view video while the vehicle is moving. Find a safe place to park and engage the parking brake.

9.If you experience problems during installation, consult your nearest DUAL dealer.

10.If the unit malfunctions, reset the unit as described on page 12 first. If the problem still persists, consult your nearest DUAL dealer or call tech assistance @ 1-866-382-5476.

11.To clean the monitor, wipe only with a dry silicone cloth or soft cloth. Do not use a stiff cloth, or volatile solvents such as paint thinner and alcohol. They can scratch the surface of the panel and/or remove the printing.

12.When the temperature of the unit falls (as in winter), the liquid crystal inside the screen will become darker than usual. Normal brightness will return after using the monitor for a while.

Additional Notes:

1.When extending the ignition, battery or ground cables, make sure to use automotive-grade cables or other cables with an area of 0.75mm (AWG 18) or more to prevent voltage drops.

2.Do not touch the liquid crystal fluid if the LCD is damaged or broken. The liquid crystal fluid may be hazardous to your health or fatal. If the liquid crystal fluid from the LCD contacts your body or clothing, wash it off with soap immediately.

This device complies with part 15 of the FCC rules and regulations.

Operation is subject to the following two conditions:

1)This device may not cause harmful interference, and

2)This device must accept any interference received, including interference that may cause undesired operation.

4

Image 5
Contents XDVD8182 Safety NotesCopyright Notes Table of Contents XDVD8182 Preparation Additional Notes Safety InformationTo prevent damage or injury Getting Started PreparationBefore You Start Rear view camera Wiring Notes Subwoofer outputCenter output Wiring Diagram Optional A/V Connections IR Remote Preparation Insert the battery holderMonitor Notes Control Locations Monitor ClosedControl Functions Monitor Closed Control Locations Monitor Open Control Functions Monitor Open Disc-in indicator Monitor Angle pqControl Locations Remote Control Functions Remote General Operation Power On/Off Monitor Open/Close Monitor Angle PositionMode Volume MuteSharpness Contrast Color Brightness Tint Cvbs Screen ControlsPress Band to increment from FM1, FM2, FM3, AM1 FM1 Time Loud LOCRapid Dial Main Menu AccessGeneral Setup Menu General Setup MenuStep General Setup Adjusting Radio Frequency12Hr Clock Mode Step Steps 24Hr Clock Mode General Setup Adjusting the ClockSystem Recommended that You choose your own Digit passwordHot line for support System Standby Screen Setup MenuScreen Setup Menu Screen Setup Setting TFT Brightness Screen Setup Setting TFT Angle Screen Setup Touch Screen Calibration AM/FM Tuner TFT Display Clock Preset page up LOCAL/DISTANCE selectionAM/FM Tuner Operation LOC/DX Radio Station Storing Radio Stations Preset Up/DownXDVD8182 Operation First situation is while driving DVD Operation Parking Brake InitializationDVD Operation DVD Disc SymbolsInsert CD/DVD with label facing upwards DVD Loading Slot Inserting a DiscDVD Operation Touch Screen Controls DVD Operation Touch Screen Controls Touch Area E DVD Transport Control OSD Search by Time example Searching a DVDYou can also touch Area E and use DVD Setup Menu Language DVD Setup Menu Audio Center Control Rear Control Down Sampling Normal Wide View Mode DVD Setup Menu VideoPress Speaker icon to select from the following menus DVD Setup Menu SpeakerDVD Setup Menu Speaker Press Pro Logic II icon to select from the following menus DVD Setup Menu Pro LogicSelect desired dimension Press Rating icon to select from the following menus DVD Setup Menu RatingRating Setting Parental Password Override CD User Interface CD OperationPrevious/Next Playing CD-DA discs Selecting by KeypadMP3/WMA User Interface MP3/WMA OperationPlaying MP3/WMA files Selecting by Keypad Media Compatibility Playback Order Media CompatibilityTransfer Bit rates Recommended SettingsAdditional MP3/WMA Information What to do? Limited One Year WarrantyTroubleshooting Specifications XDVD8182 Operation