Dual XR4120 owner manual Preparation, Before You Start, Getting Started

Page 2

XR4120 INSTALLATION

Preparation

Please read entire manual before installation.

Before You Start

Disconnect negative battery terminal. Consult a qualified technician for instructions.

Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight, or where it would be subject to dust, dirt or excessive vibration.

Getting Started

Remove trim ring from unit.

Remove 2 transit screws located on top of the unit.

Insert the supplied keys into the slots as shown, and slide the unit out of the mounting sleeve.

Install mounting sleeve into opening, bending tabs to secure.

Connect wiring harness and antenna. Consult a qualified technician if you are unsure.

Certain vehicles may require an installation kit and/or wiring harness adapter (sold separately).

Test for correct operation and slide into mounting sleeve to secure.

Snap trim ring into place.

REMOVAL KEYS

MOUNTING SLEEVE

HEAD UNIT

INSTALLATION

MOUNTING KIT

OR DASHBOARD

TYPICAL FRONT-LOAD

DIN MOUNTING METHOD

2

Image 2
Contents XR4120 Getting Started PreparationBefore You Start Wiring Diagram FuseControl Locations Receiver Control Locations Remote General Operation 10L left to 10R right. L=R represents equal balance Sold separately AM/FM Tuner OperationUSB / SD Card Operation Playing Music Track SelectUSB / SD Card Operation Sampling Frequency Rates Transfer Bit ratesTroubleshooting Limited One Year Warranty What to do?FCC Compliance Dimensions 7 x 7 x 2 178 x 178 x 50 mm SpecificationsFM Tuner AM Tuner General Tuning range 87.5MHz-107.9MHz XR4120 Operation Dual Electronics Corp Toll Free 9AM-5PM EST, Monday-Friday