Dual XHDR6435 owner manual General Operation

XHDR6435 OPERATION

General Operation

Faceplate Removal	Press RELEASE and pull away from the left side to remove.
	To re-install, insert right side of faceplate first then push
	left side to secure.
Semi-Permanent	Remove trim ring and install supplied #1 x 7/32” Phillips
Faceplate Installation	head screw through left side of mounting frame into faceplate.
Power On/Off	Press		or any other button (except eject) to turn the unit on.
	Inserting a disc will turn the unit on automatically. Press and
	hold	to turn the unit off.
Mode	Press MODE to select between AM/FM, CD player, operation
	of iPod, USB, auxiliary input and Bluetooth modes. Modes of
	operation are indicated in the display.
	Note: "HD RADIO" will appear when the HDM90 HD Radio™
	tuner is connected (sold separately). CD mode will not
	appear unless a CD is inserted. USB mode will not appear
	unless a USB device is connected. Operation of iPod mode
	will not appear unless an iPod device is connected. Bluetooth
	mode will not appear unless the BTM60 Bluetooth module is
	connected.
Auxiliary Input	Insert 3.5 mm plug to connect your portable audio device.
Steering Wheel Interface	The steering wheel interface input located on the back of the
Input	head unit allows connection to the PAC (Pacific Accessory
	Corporation) SWI-PSinterface module (sold separately). Visit
	www.pac-audio.com for details.
	To configure steering wheel controls, follow the instructions
	provided with the PAC SWI-PSinterface module. After
	installing the interface module, insert the module's 3.5mm
	jack into the port on the back of the head unit.
Volume	Adjust volume using volume knob (00-46).
Mute	Press MUTE to silence the audio. “MUTE” will flash in the
	display. Press MUTE again to cancel.
Reset	Press to RESET the unit upon initial installation or if
	abnormal operation occurs. The reset button is located
	behind the faceplate.
Display	Press DISP to select between clock and different types of
	information, such as radio frequency, CD track or MP3 CD/
	USB song information.
Set the Clock	With the unit on, press and hold DISP until the clock begins
	to flash, then release. Press TUNE nnto adjust the
	hours and TUNE llto adjust the minutes. Press DISP
	momentarily to save the selected time.
6