(C)SIGNAL/CLIP INDICATORS
Each of the three inputs is monitored by an indicator that provides status on the incoming audio signal. The SIGNAL indicator is illuminated when there is an audio signal present with a level greater than
(D)INPUT 1 & INPUT 2 INPUT JACKS
A combination input on each channel allows for either XLR or ¼” TRS cable types.
(E)INPUT 3 INPUT JACKS
A pair of ¼” TS unbalanced input jacks is provided on this channel for stereo connections such as a keyboard or media device. Devices with RCA outputs can use these inputs with the appropriate cable or plug adapter. Both input jacks on this channel are summed into one mono signal.
(F)THRU 1 & THRU 2
The balanced XLR outputs THRU 1 & THRU 2 are parallel connections to the respective INPUT 1 and INPUT 2. The level controls for INPUT 1 & INPUT 2 will not affect the signal on the direct output connection.
(G)MIX OUTPUT
This is a balanced XLR output that is a sum of all three input channels. This output is not affected by changes to the Main Volume knob or the custom features but is affected by the levels set on each channel level knob. This connection is designed to provide an output which combines all three input channels together for connecting to another P1500X powered speaker or a recording device.
(H)MAIN VOLUME KNOB & REMOTE VOLUME CONTROL
It is highly recommended to have the volume set to the minimal (MIN) level upon initial system
(I)INDICATORS
Three indicators provide operating condition status on the P1500X:
1)The POWER indicator (green) will illuminate when power is properly applied to the P1500X and the main power switch is ‘ON’.
2)The LIMITER indicator (yellow) will illuminate when the P1500X automatically reduces the sound output to prevent damage to the speaker. While the P1500X is producing sound, it is suggested to reduce the volume level so the LIMITER indicator does not illuminate. Continuing use of the P1500X while this indicator is illuminated may result in a protect condition where no sound can be produced. Note, upon initial power up the indicator will blink. This is normal behavior as it will indicate the firmware version in the unit.
3)The PROTECT indicator (red) will illuminate when the P1500X automatically places itself into a condition where sound output is shutoff. This condition may be the result of excessive limiting, an excessive heat condition, or a low voltage condition. These conditions all can cause significant damage to the product.
9