Mounting

SX SERIES INSTALLATION

1.Determine where the speakers will be mounted. Make sure the area is large enough for the speaker

to mount evenly. Also ensure the mounting location is deep enough for the speaker to fit.

2.Refer to the specification chart to determine the proper diameter hole to cut for your speaker model.

3.If supplied, use the plastic mounting ring as a template to mark the locations for the mounting screws. Drill the holes with a 3/32" bit.

4.Be sure to observe proper polarity when connecting the wires.The speaker's positive terminal is indicated with a "+" symbol.

5.Fit the speaker to the hole cut-out. Mount the speaker using the supplied screws. If the speaker grill is to be used, insert 4 screws into the grill holes and then mount the speaker.

Standard Rear Deck Installation

Grille

Mounting hole

Cut-out

Speaker

Standard Door Installation

Grille

Speaker

Mounting hole

Cut-out