PYLE Audio PLBASS10 owner manual Mounting the subwoofer, Solution

Mounting the subwoofer

1.Find a suitable location in the vehicle in which to mount the amplifier. A typical location is shown below:

2. Make sure there is sufficient air circulation around the intended mounting location.

3. Mark. the location for mounting hole screws by positioning the cabinet where you wish to inst all it. Make a small mark to identify the position and remove the unit. Thoroughly dean the area you plan to attach the subwoofer, using a vacuum cleaner. Then attach the supplied double adhesive tape, and put the subwoofer in the place and press down on it securely.

Troubl....ootlng

If you experience operation or performance problems wtIh this product, compare your installation with the electrical wiring diagram on the previous pages. If problems persist, read the following troubleshooting tips which may help eliminate the problems.

PROBLEM	POSSIBLE REASON		SOLUTION
	_ i'D+12.bf paM!!"..we	_ Check. lJsae and c:onnacllons 1D batIB
Nat MIdIIIlII 00. PtMa - No pcMIlI" b ft!I"I"de ..we		-	C2"Iec:k remote on connections 1D head unit
lB) not 'on'	-FLBe belen	-	Replace fuse with correct type and
			amperage
	-FIBJ liMn	-	Replace fuse with correct type and
Net v.tlIki'Q but sBIus			amperage

PLBASS10

10" Super Slim Active Subwoofer

lED '00'

_ fvtova unit to vanlBd area

No .....

- AnlfI'ertlo I"d.

' _lH

- GI!Ih ariel rD: II1II: ~

-Co. r IS

_ Tum head unit dCMn

-Check heed unit volume level

-Ensure you have set up the amplifier gain level control

-Check all paovar, remote on and grcxn::l

"""""""""

OWNER'SMANUAL

PYLE'

www.pyleaudio.com