PYLE Audio PLCDCS100 LCD Liquid Crystal Display Band Button, LOUD/SUB Woofer Button, Open Button

Page 3

TROUBLE SHOOTING

Before going through the check list, finish wiring connection. If there still are any question after finish testing the items in the following list, consult your nearest service dealer.

Symptom

Cause

Solution

 

 

 

The compact

The volume control is turned

Turn up the volume control.

disc or tape

down.

 

does not play

 

 

The power connections are not

Check the +12V and ground

when inserted

wired correctly.

connections.

into the unit.

 

 

The sound from

The road surface is rough.

Wait for the road surface to

the CD player

 

improve before playing a disc.

skips.

 

 

The unit is not mounted

Install the unit securely. Be sure to

 

 

securely.

use the rear strap if the vehicle

 

 

does not provide support for the

 

 

rear of the unit.

 

 

 

 

The disc is defective.

Try another disc. If it plays properly,

 

 

the first disc may be defective.

 

The disc is dirty.

Clean the disc.

 

 

 

No power.

The vehicle ignition is switched

Switch the ignition to the "ON" or

 

off.

"ACC" position.

 

 

 

 

The fuse is blown.

Replace the fuse with another 15A

 

 

fuse.

 

 

 

The unit does

The microcomputer has been

Eject the disc or tape, then insert it

not work

affected by electrical noise.

again.

properly (Eject,

 

 

 

Turn the power off and then on

Load, Play).

 

 

again.

 

 

 

 

 

No radio

The antenna cable is not

Insert the antenna cable firmly into

reception.

connected.

the antenna jack on the unit.

 

 

 

The radio does

The signals are weak.

Select a station using manual tuning.

not stop on any

 

 

stations when

 

 

automatic

 

 

tuning is used.

 

 

 

 

 

5.LCD (LIQUID CRYSTAL DISPLAY)

6.BAND BUTTON

Press it to switch from tape, CD or CDC mode to radio mode, then press it repeatedly to select the band and the LCD screen will be shown as below:

FM 1 FM 2 FM 3 AM 1 AM 2

7.21. TUNE/SEEK/TRACK UP OR DOWN, FF/RW BUTTONS

In radio mode, press UP or DN button shortly to start automatic tuning and stop at the next receivable station; press UP or DN button for more than 2 second to change into manual tuning mode.

In tape mode, press UP or DN button to fast forward or rewind the tape, and press TAPE button to resume normal tape playing.

In CD player mode, press UP or DN button to skip to the beginning of the next track or one of the track currently playing. Press the DN button twice to skip to the beginning of the previous track. Press and hold UP or DN button for more than 2 seconds to search quickly (with sound) in the forward or reverse direction.

8.LOUD/SUB WOOFER BUTTON

press it shortly to enhance the bass effect during bass mode. Press it more than 2 seconds, SUB WOOFER will be turned on.

then press SEL button to select the sound mode such as volume, bass, treble, balance and fader, and then press + or - button to increase or decrease the volume level of the selected sound mode. Press it more than 2 seconds again to turn off the SUB WOOFER.

9.OPEN BUTTON

Press it to flip the panel down from the unit. But you can't take the panel away because it is still linked with the unit by metal plates.

10.MUTE BUTTON

Press it to eliminate the sound immediately.

11.DISPLAY BUTTON

Press it repeatedly to turn on the preset equalizer curves: FLAT, POP, CLASSIC and ROCK, and the sound quality will be changed.

Image 3
Contents 200WATTS Remote Control Basics Battery ReplacementLocation and Function of Controls Specification Open Button LCD Liquid Crystal Display Band ButtonTUNE/SEEK/TRACK UP or DOWN, FF/RW Buttons LOUD/SUB Woofer Button15.RPT/METAL Button InstallationTape Button 14.RDM/PAUSE ButtonAPS Button Precautions and MaintenancePower Button Disc Selecting ButtonsRight Disc Play