PYLE Audio PLDVD97N Basic operation, Play, Stop playing Eject, Use of Remote Sensor

Basic operation

4. Basic operation

If you have connected the product to TV, all power lines have been plugged into receptacles, and loaded the batteries into remote control, so you can play the player.

Turn on TV power

If you have connected amplifier, you should also turn it on, and select proper amplifier mode according to the type of discs to be played.

Play

1. Push [POWER] in the player.

Control TV remote control to shift TV to proper video input mode (VIDEO IN).

2.Push open/close eject player or [ EJECT] buttons on the remote control to the tray.

Load a disc in the tray, with label side upward (see following figure), place single disc in the tray,

3. Push [ ] PLAY/PAUSE

The player will close the tray automatically and begin to read it, It can identify different disc format then display it on the screen of DVD frontal panel, afterwards if automatically plays disc, If directory or menu picture disply in the screen, you can push the direction buttons [UP], [DOWN],[LEFT] and [RIGHT] buttons in the remote control to move lighting band to desired track, You can directly push number buttons to select track.

While playing push [ ] to pause the

playback, push [ ] again to resume play

Mute (available to analog audio output Signal only)

Push [MUTE] to silence the sound of the player, press it again to return to normal state.

Stop playing EJECT

1. Push [EJECT]

unload the disc until the tray is ejected. After stopping playing, unload the disc until the tray is ejected.

2.Push [EJECT] to close the tray

3.Press [POWER] to turn off the player.

Then turn off power of all connected equipment.

The use of REMOTE SENSOR

If you want to put the DVD player in where you can not see, please insert REMOTE SENSOR in the REMOTE SENSOR INPUT, and put REMOTE SENSOR on where you can see in automobile, you can control the DVD p l a y e r s o l o n g a s l e t R E M O T E CONTROL toward REMOTE SENSOR.

Basic operation