features and specifications
MONO BLOCK AMPLIFIER PLA-1200
power supplies Stiffly regulated PWM power supplies. MOSFET switches maintain rated power over a wide range of battery voltages.
output power @ 14.4v DC, 50Hz | |
RMS Power at @ 4 Ohms | 200W MONO |
RMS Power at @ 2 Ohms | 350W MONO |
sub sonic control
bass boost level control
crossover low pass filter
high pass subsonic filter
protection circuitry remote
When the sub sonic selector switch is in "ON" mode, this filter control permits continuously variable adjustment from 10 to 100Hz.
This control permits adjustment of the bass level up to an increase of approximately up to 18dB.
Adjustable from 20Hz to 250Hz with a slope of 24dB per octave.This allows for the adjustment of the upper point of the frequency bandwidth and the respective subwoofer.
Adjustable from 15Hz to 40Hz with a slope of 24dB per octave.This allows for the attenuation of frequencies that are mostly inaudible and cause unnecessary strain on the amplifier.
Protection against thermal, overload and short circuit conditions.
This amplifier come complete with a compact remote GAIN CONTROLLER which can be conveniently mounted on or under the dashboard of your car.
RMS Power at @ 1.3 Ohms | 600W MONO |
| |
Maximum Power Output | 1900W MONO |
| |
frequency response | 20 |
| |
input impedance | 10K Ohms | 4 | |
input sensitivity | 250mV~4V Adjustable | ||
| |||
power supply voltage | 14.4V DC Neg. Ground |
| |
min speaker lmpedance |
| ||
T.H.D | 0.1% |
| |
S/N ration | >90dB |
| |
fuse | 20A x 2 |
|
dimensions (W x H x L)
mm270 x 36 x 305
inches 10.63 x 1.42 x 12