4. Reconnect the terminal of the battery of procedure.
Notes
●If your vehicle ignition does not come with an ACC position, connect the ignition cables
to a power source that can be turned on and turned off with the ignition key. If you connect the ignition cable to a power source that receives a constant voltage supply, as with battery cable, the battery may be overloaded.
●If the fuse blows, first check whether the cables have caused a short circuit or not, then replace the old fuse with a new one of the same type.
●Do not let unconnected cables or terminals touch the metal on the car of anything else
conducting electricity. Besides, to prevent short circuits, do not remove the caps from unused terminals or from the ends of the unconnected cables.
●After the monitor unit is installed, please check whether the brake lamps, blinkers,
wipers, etc…on the vehicle can work properly.
.
●Please cover unconnected cables or terminals with rubberized tape or insulators.
Troubleshooting |
|
|
Problems | Possible Cause | Remedy |
No picture and | 1. Power wire is connected | 1. Check the power wire |
sound when the | improperly or fuse is blown. | and replace the fuse. |
monitor is turned | 2. System cable isn’t | 2. Check the system cable |
on | connected or contacts | or replace a new one. |
| unwell. |
|
Blurry picture on | Interfered by | The reception of signal will |
the screen | strong interference (e.g. | get better immediately once |
| motorbike, high voltage wire, | leaving the interference |
| transformation station or | area. |
| aircraft etc…) |
|
No function on the | 1. The battery of remote | 1. Change a new rating |
remote control (or | control has exhausted. | battery. |
operation distance | 2. Remote control is destroyed. | 2. Contact with the dealer |
is shortened) |
| and then change a new |
|
| remote control. |
The picture on the | The equipment locates at a low | This is the character of LCD |
screen is relatively | temperature area. | monitor in low temperature, |
dark. |
| it will restore to normal |
|
| brightness after powering on |
|
| the monitor for few minutes. |
14