AD-C1200 and AD-C1200BB Installation
The
AD-C1200BB Installation
The
1.There are 5 wiring ½" & ¾" knockout locations available on the
2.Skip this step if you are using electrical conduit for the facility’s loudspeaker signal wiring. Install a Wire Clamp Fitting into the selected knockout holes.
Caution: The
3.Secure the
4.Route the facility’s loudspeaker signal wires through the knockout hole(s) and to the ceramic terminal block.
•If you are using Wire Clamp Fittings, make sure there is enough wire to strip, tin, and connect the wires to the ceramic terminal block. Do not secure the Wire Clamp Fitting at this time.
•If you are using electrical conduit, secure the conduit to the back box.
5.Strip the ends of the wires to approximately 0.4" (10 mm), and tin the ends of the wires.
6.There are two wires already connected to the terminal block; the striped wire is negative, the solid color wire is positive (Figure 24) . Do not remove these wires, but ensure the locking screws are tight. Connect the facility’s loudspeaker signal wires to proper corresponding connections in the terminal block using a #1 Phillips head screwdriver.
Note: For
7. If you are using a Wire Clamp Fitting, secure it and make sure there is enough slack in the wires inside the box to provide for stress relief.
15