General Operation

OPERATION

Note: In this product design, there has different sound accompanying with every button pressed and the sound is designed differently according to the customers.

•ON/OFF

Switch on the unit by pressing POWER button (9). When system is on, press POWER button (9) again to turn off the unit.

•OPEN THE FRONT PANEL

Press OPEN button (7) to fold down the front panel.

•SOUND ADJUSTMENT

Press PUSH SELECT button (10) to select audio mode shown in the below sequence.

VOLUMEBASSTREBLE BALANCEFADER (For Fader Version Only)

By rotating the knob (10) clockwise or counter-clockwise, it is possible to adjust the desired sound quality.

If adjustment has not been done in BAS/TRE/BAL/FAD mode, it is returned to the volume select mode (initial) 5 seconds later.

Note: Only in fader version, fader is effective.

•LOUDNESS

Press the LOUD button (3) to loudness function and display will show “LOUD”. Press it again to release this function.

•DISPLAY

Press the DSP button (15) can switch between frequency or play time display and clock display.

To set clock, hold down DSP button

(15) until the clock is shown on display then press TUNE/TRACK/SKIP button (17) to change hours or TUNE/TRACK/SKIP button (16) to change minutes.

•SELECT MODE

Press the MODE button (6) to choose desired listening mode. (e.g. radio, CDP, CDC, tape, TV or AUX mode)

•MUTE

Press the MUTE button (2) to silence the receiver. Press it again to release the mode.

•LIQUID CRYSTAL DISPLAY

Exhibit current frequency and activated functions on the display (27).

•EQUALIZATION

Press EQ button (12) to select SOUND EFFECT as shown in below sequence:

NORMAL CLASPOP JAZZ

Press EQ button (12) over 1 second, graphic display type will display on the LCD and then press TUNE/TRACK/SKIP button (16) or TUNE/TRACK/SKIP button (17) to select graphic display type as follows:

DNCO1DNCO2 DNCO3 DNCO4 DNCO5

•REMOTE SENSOR

Point the remote control handset to the remote sensor IR (23).

Press the function keys on the handset to control the system.

•AUXILIARY INPUT

The unit can be connected to a portable audio player through the AUX IN jack (11).

•RESET

RESET button (28) must be activated with either a ball point pen or thin metal object. The RESET button (28) is to be activated for the following reasons:

-Initial installation of the unit when all wiring is completed.

-All the function buttons do not operate.

-Error symbol on the display.