Radio Shack owner manual ET-3222 Trim Fone, Read this First, Connecting the Phone, Care

ET-3222 Trim Fone

OWNER’S MANUAL — Please read before using this equipment.

zFlash	z Touch-Tone or Pulse (rotary) Dialing
z Redial	z Desk or Wall Mount

zRinger On/Off Switch z Handset Volume Control

READ THIS FIRST

We have designed your telephone to conform to federal regulations and you can connect it to most telephone lines. However, each device you connect to the phone line draws power from it. This power draw is the device’s ringer equivalence number, or REN. The REN is shown on the bottom of your phone.

If you are using more than one phone or other device on the line, add up all the RENs. If the total is more than five (or three in rural areas) your phones might not ring. If ringer operation is impaired, remove one of the devices from the line.

If your phone causes problems on the phone line, the telephone com- pany can disconnect your service. The phone company tries to notify you in advance. If advance notice is not practical, the telephone com- pany notifies you as soon as possible and advises you of your right to file a complaint with the FCC.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

This symbol is intended to inform you that parts inside the telephone present a risk of electric shock.

This symbol is intended to alert you to important operating and servicing in- structions included in the papers with the telephone.

CONNECTING THE PHONE

To use the phone on a desk or to mount it on a wall without a wall plate, connect the handset cord and the supplied long modular phone cord as shown.

Note: To mount the phone directly on a wall, you need two screws (not supplied) with heads that fit into the keyhole slots on the bottom of the phone.

The phone company can also make changes to its lines, equipment, operations, or procedures that could affect the phone’s operation. The phone company notifies you in advance, so you can take the neces- sary steps to prevent interruption of your phone service.

FCC STATEMENT

Your telephone complies with Part 68 of the FCC Rules. You must, upon request, provide the FCC registration number and the REN to your telephone company. These numbers are shown on the bottom of your phone.

Note: You must not connect your telephone to:

1/8" (3.5 mm)

31/4"

(82.55 mm)

1/8" (3.5 mm)

To mount the phone di- rectly on a wall, drill two holes 31/4 inches (82.55 mm) apart. Then thread a screw into each hole, letting the heads extend about 1/8 inch (3.5 mm) from the wall. Fit the keyhole slots over the screw heads and slide the phone downward to secure it.

•coin-operated systems

•party-line systems

•most electronic key phone systems

CARE

Keep the phone dry; if it gets wet, wipe it dry immediately. Use and store the phone only in normal temperature environments. Handle the phone carefully; do not drop it. Keep the phone away from dust and dirt, and wipe it with a damp cloth occasionally to keep it looking new.

Modifying or tampering with the phone’s internal components can cause a malfunction and invalidate its warranty. If your phone is not performing as it should, take it to your local RadioShack store for as- sistance.

To mount the phone on a wall plate, connect the handset cord and the supplied short modular phone cord as shown. Fit the keyhole slots over the wall plate studs and slide the phone downward to secure it.

Note: The USOC number of the jack to be installed is RJ11C (RJ11W for a wall jack).

© 2000 RadioShack Corporation.

All Rights Reserved.

RadioShack and RadioShack.com are trademarks used by RadioShack Corporation.