Power Acoustik OVN2-800, OVN2-600, OVN2-2200, OVN4-1600, OVN4-840, OVN4-1200 Table of Contents

TABLE OF CONTENTS

PLANNING YOUR SYSTEM	3
WIRING CONNECTION	4
CONTROL FUNCTIONS	5, 6, 7
SPEAKER CONNECTION MONO CHANNEL	8, 9
2 CHANNEL	10, 11
4 CHANNEL	12, 13, 14
TROUBLE SHOOTING GUIDE	15
SPECIFICATION	16, 17
WARNING	18

PLANNING YOUR SYSTEM

Before beginning the installation, consider the following:

1. Do you plan to add additional mobile electronics equipment in the future?

If you plan to expand your system by adding other components sometime in the future, ensure adequate space is left and cooling requirements are met.

2. Should you use high or low level inputs?

Your Amplifier has been designed to accept Low-Level(Pre-Amp outputs from your radio) source signal. If your radio/source is equipped with Pre-Amp outputs, it is possible to utilize them to drive the Amplifier and the 2 front speakers. Then, use the built-in power of your radio to drive the 2 rear speakers.

3. Are your components matched?

The RMS power rating of your speaker(s) must be equal or greater than the RMS power rating of your amplifier. Your speaker(s) also must be 2 - 8 Ohms impedance for stable amplifier operation. Impedance information is normally printed on the speaker basket or magnet.

4. Where will the amplifier be installed?

Consider both the length of your leads, and routing when determining the mounting location. It is best to run power and RCA wiring on opposite sides of the vehicle to prevent induced noise. Pre-amp input jacks require a length of high quality shielded male to male RCA patch cord.

- 3 -