MTX Audio TA3404 specifications Troub le Shooting, Problem Cause

Page 5

Setting For Components and Separates: First enable the electronic crossover by selecting the “ON” position of the X-OVER switch, then select the “H-PASS” (High pass) position on the L-PASS/H-PASS switch.

By selecting this you are giving the speakers 85Hz – 20kHz. The 12dB/Oct roll off means that the frequencies under (lower then) the set 85Hz, will taper off at moderate slope.

Setting For Full Range (No Crossover): To disable the electronic crossover, select the “OFF” position of the X-OVER switch. This setting will allow the amplifier to play all frequencies.

4.Remote Subwoofer Level Control (Remote Sub) – Lets say the amplifiers gain is set at half way, when the remote subwoofer level control is plugged in, you now have external control of the gain from zero – half way. The installation of this level control is NOT necessary to get full power from amplifier.

5.Prizm EFX – Now that you have completed adjusting all your amplifier settings, you can set the lighting effects to you personal taste.

Selecting Colors: You can change the backlit colors simply by turning the Pot labeled PRIZM COLOR located in the MTX PRIZM EFX section of the control panel left or right. Starting at the most counter clockwise position, the colors range from RED, GREEN, BLUE, and RED again or any color in between making the combination unlimited.

Selecting The EFX Feature: You can switch Prizm EFX lighting to “pulsate” with beat of music. Simply depress the button labeled PRIZM EFX located in the in the MTX PRIZM EFX section of the control panel to turn this feature on or off.

Troub le Shooting

Read this if you want to be a do-it-yourselfer or give us a call at 800-CALLMTX.

PROBLEM

CAUSE

No LED indication

No +12V at remote connection

 

No +12V at Power connection

 

Insufficient ground connection

 

Blown power fuse

LED on, no output

Volume on head unit off

 

Speaker connections not made

 

Gain control on amplifier off

 

Signal processing units off

 

All speakers blown

Output distorted

Head unit volume set too high

 

Amplifier gain set too high

Balance reversed

Speakers wired L + R reversed

 

RCA inputs reversed

Bass is weak

Speakers wired out

 

phase

 

Not using MTX woofers

Blowing fuses

Excessive output levels

 

Amplifier defective

SOLUTION

Supply +12V to terminal

Supply +12V to terminal

Verify ground connection

Replace fuse

Increase volume on head unit Make speaker connections Turn up gain

Apply power to signal processor Replace speakers

Lower head unit volume

Lower amplifier gain

Wire speakers with correct orientation Reverse RCA input

Wire with correct of phase

Buy MTX woofers

Lower volume

Return for service

Image 5
Contents Specifications FeaturesIntroduction Before Starting Installation MountingConnections Feature Setup and Adjustments Troub le Shooting Problem Cause