Metra Electronics AW-200GM All vehicles DIN head unit provisions, Secure by bending metal locking

Page 31

Kit Assembly 99-2001, AW-200GM

All vehicles – DIN head unit provisions

	1.	Locate the factory wiring harness in the
	1.	Locate the factory wiring harness in the
		dash. Metra recommends using the
		proper mating adapter from Metra or
		AXXESS. Re-connect the negative
		battery terminal and test the unit for
		proper operation.
		Note:When installing a DIN head unit
		you will need to cut and remove the
		shaft supports in the radio housing.
		(Figure A)
	2.	Slide DIN cage into the Radio Housing
	2.	Slide DIN cage into the Radio Housing	(Figure A)
		and secure by bending metal locking	(Figure A)
		and secure by bending metal locking
	3.	tabs outward. (Figure B)
		tabs outward. (Figure B)
		Slide radio into DIN cage. (Figure B)
	4.	Reassemble dash in reverse order
		of disassembly.

(Figure B)

31

Image 31

Contents Utility Knife Phillips Screwdriver Socket Set GM multi-kit 1994 99-2001 AW-200GMBuick ApplicationsTable of Contents Aztec Bonneville Grand Am Montana Sunfire Ascender 290/I370 280/I350Buick Century 1997-2005 Buick Regal Buick Le Sabre Buick Park Avenue Remove radio. Figure D Buick RendezvousRemove 3 Phillips screw to remove climate control Buick RivieraBuick Roadmaster Remove 6 9/32 screws inside glove box Buick SkylarkDash Disassembly 99-2001, AW-200GM Remove 2 9/32 hex-head screws from the knee bolster panel Chevrolet Cavalier Figure a Chevrolet Express Van GMC Savanna Remove 3 9/32 bolts to remove radio. Figure D Instrument cluster panel. May not beRemove 2 Phillips screws from the knee panel Chevrolet ImpalaChevrolet Malibu Chevrolet Malibu Classic Remove 2 Phillips screws under the instrument clusterUnclip the trim panel above the pedals Chevrolet Monte CarloRemove 2 Phillips screws inside instrument cluster Chevrolet TrailblazerDash Disassembly 99-2001, AW-200GM Near the floor Open lower storage door and remove 7mm screws insideRemove lower storage compartment Remove 3 screws and remove radio. Figure C GMC Envoy Isuzu Ascender Oldsmobile Bravada Buick RanierRemove. Figure D Hummer H2Remove 1 10 mm bolt to right of shift lever. Figure a Slide control assembly rearwardsRemove 3 9/32 screws that hold the radio in. Figure C Unclip and remove shifter trim panel Oldsmobile AchievaOldsmobile Alero Unclip the dash trim bezelOldsmobile Cutlass Oldsmobile Cutlass Supreme Oldsmobile AuroraOldsmobile Ninety-Eight Oldsmobile Eighty-EightOldsmobile Intrigue Oldsmobile LSS Oldsmobile Regency Pontiac Bonneville Pontiac AztecPull out cup holder inserts Unclip the bezel and remove Pontiac Grand AmPontiac Sunfire Unsnap and remove radio trim bezelSecure by bending metal locking All vehicles DIN head unit provisionsAll vehicles Shaft head unit provisions Page Page Page REV /08/11