
ALL VEHICLES
3 | 4 |
Fig. A | Fig. A |
KIT FEATURES
Shaft and DIN unit provisions
Equalizer provisions
KIT COMPONENTS
99-3410 AW -341GO DW -3410
INSTALLATION
| Fig. B |
| Slide the |
aftermarket head unit into the kit and secure with shaft nuts. (see Fig. A)
DIN HEAD UNITS: Cut and remove the shaft supports. Slide the DIN cage into the Radio Housing and secure by bending the metal locking tabs down. Slide the aftermarket head unit into the cage until secure. (see Fig. B)
Fig. B
IF AN EQUALIZER WILL BE INCLUDED :
Slide the aftermarket equalizer into the back of
the Radio Housing. Using the hardware included with the equalizer, mount the unit to the kit. (see Fig. A)
IF AN EQUALIZER WILL NOT BE INCLUDED: Snap the Equalizer Dummy Plate into the Radio Housing. (see Fig. B)
Radio Housing
Equalizer
Dummy Plate
INSTRUCTIONS
APPLICATIONS
CAR | PAGE |
CHEVROLET |
|
Tracker | ..........................................................1 |
GEO |
|
Metro | 1 |
Tracker | ..........................................................1 |
SUZUKI |
|
5
A
B
C
D
A) Strip wire ends back ½"
B) Twist ends together
C) Solder
D) Tape
Locate the factory wiring harness in the dash. Metra recommends using the proper mating adaptor and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit).
6
(4) #8 x 1" Phillips
(4) Speed Clips
TOOLS REQUIRED
Phillips screwdriver
Cutting tool
Aerio 2003 | 2 |
Esteem | 2 |
Sidekick | 1 |
Swift | 1 |
Vitara series | 1 |
WIRING AND ANTENNA CONNECTIONS (Sold Separately)
Harness:
•Please visit www.metraonline.com for specific interface applications
Antenna Adapter:
•
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills
by enrolling in the most recognized and respected mobile electronics school in our industry.
Log onto www.installerinstitute.com
or call
www.metraonline.com
3 | REV. |
Wrench
© COPYRIGHT