Metra Electronics CK-612MI manual Eagle Talon / Mitsubishi Eclipse, Fig. B

EAGLE Talon / MITSUBISHI Eclipse

PLYMOUTH Laser 1990-94

EAGLE Talon / MITSUBISHI Eclipse 1995-98

1

1

Disconnect the negative battery terminal to prevent an accidental short circuit. Unclip the radio trim bezel (the factory pocket will be attached). Remove (4) screws securing the factory head unit and disconnect the wiring.

2

"B"

"B"

Cut and remove all mounting tabs on the Radio Housing EXCEPT tabs "B". The mounting tabs can be identified by the stamped letter on the back of each tab.

Center

Radio console trim bezel

Disconnect the negative battery terminal to prevent an accidental short circuit. Slide the front seats forward and remove (1) cover cap and (1) Phillips screw from each side of

the center console. Unsnap the

cupholder/ashtray assembly and remove (2) Cut and remove mounting tabs "A" and "B"

Phillips screws exposed. Unclip the radio on the Radio Housing. Cut and remove the

trim bezel and remove (2) Phillips screws lower rib from the radio opening. exposed. Unscrew the shifter knob.

3

Fig. A

Fig. B

Fig. C

DASH TRIM BEZELS WITH A DIVIDED RADIO OPENING: If keeping the factory pocket is NOT desired, cut and remove the upper rib from the radio openingand snap the Filler Bar onto the bottom of the Radio Housing. (see Fig. A). If keeping the factory pocket is desired, cut and remove the upper rib from the radio opening and the bottom portion of the Radio Housing. (see Fig. B). Skip to the Installation Instructions for ALL VEHICLES on Page #12.

DASH TRIM BEZELS WITH AN UNDIVIDED RADIO OPENING: Cut and remove the lower rib from the radio opening and the top portion of the Radio Housing. (see Fig. C). Skip to the

Installation Instructions for ALL VEHICLES on Page #12.

Disconnect the cigarette lighter and light wiring. Lift up on the center console and remove. Remove (4) Phillips screws securing the factory head unit and disconnect the wiring.

3

"G"

"G"

"G"

Fig. A "G" Fig. B

Cut and remove all mounting tabs on Bracket Set #2 EXCEPT tabs "G". The mounting tabs can be identified by the stamped letter on the back of each tab. (see Fig. A). Once the mounting tabs are removed, cut and remove the SHADED portions of the Brackets. (see Fig. B). Skip to the Installation Instructions for ALL VEHICLES on Page #12.

4 5