TOYOTA MR2 1985-86
TOYOTA Corolla 1984-87
1
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove
(2)Phillips screws above the climate controls. Unclip the lower edge of the radio trim bezel and remove. Remove the screws securing the factory head unit and disconnect the wiring.
2 |
"C" |
"C" |
Slide Mounting Tabs #3 into slots "C" on Bracket Set #12. The Mounting Tabs, Brackets and Bracket slots can be identified by the stamped letter on each component. Skip to the Installation Instructions for ALL VEHICLES on Page #10.
1
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove
(2)Phillips screws from each side of the radio trim bezel. Remove the bezel. Remove (4) screws securing the factory head unit and disconnect the wiring.
2 | "G" | Fig. A |
|
| "F" |
| "G" |
|
| Fig. B | "F" |
|
|
2DR/3DR MODELS: Slide Mounting Tabs #3 into slots "G" on Bracket Set #1. (see Fig.
A).
4DR/5DR MODELS: Slide Mounting Tabs #3 into slots "F" on Bracket Set #1. (see Fig.
B).
The Mounting Tabs, Brackets and Bracket slots can be identified by the stamped letter on each component. Skip to the Installation Instructions for ALL VEHICLES on Page #10.
TOYOTA MR2 1987-90
TOYOTA Corolla (sed/wag-lower dash) 1988-93
1
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove
(2)screws from the top of the dash trim bezel and remove the bezel. Remove (4) screws from the factory head unit (or coin tray dummy panel) and disconnect the wiring.
2 | "I" |
| "I" |
Slide Mounting Tabs #3 into slots "I" on Bracket Set #12. The Mounting Tabs, Brackets and Bracket slots can be identified by the stamped letter on each component. Skip to the Installation Instructions for ALL VEHICLES on Page #10.
1
Disconnect the negative battery terminal to prevent an accidental short circuit. Remove
(1)screw to the right of the ignition switch. Remove (1) screw above the left speaker. Unclip the dash trim bezel (some force may be required). Remove the screws securing the factory head unit and disconnect the wiring.
2 |
"F" |
"F" |
Slide Mounting Tabs #3 into slots "F" on Bracket Set #2. The Mounting Tabs, Brackets and Bracket slots can be identified by the stamped letter on each component. Skip to the Installation Instructions for ALL VEHICLES on Page #10.
7
4