Metra Electronics 99-7310 ALL Vehicles, Strip wire ends back ½ Twist ends together Solder Tape

ALL VEHICLES

1

3 4

A

B

C

D

A) Strip wire ends back ½"

B) Twist ends together

C) Solder

D) Tape

Disconnect the negative battery terminal to prevent an accidental short circuit. Open the cupholder and remove (2) Phillips screws exposed. Lower the glove box and detach the vent cable exposed. Reach under the driver's side dash and detach (2) vent cables located above the accelerator. Unclip the dash trim bezel and remove. Remove (4) screws securing the factory head unit and disconnect the wiring.

Slide the head unit into the Radio Housing, align the holes in the head unit with the holes in the Housing and mount the unit with the screws supplied with the unit.

Locate the factory wiring harness in the dash. Metra recommends using the proper mating adaptor and making connections as shown. (Isolate and individually tape off the ends of any unused wires to prevent electrical short circuit).

2

Snap the ISO Brackets over the mounting tabs on the Radio Housing.

1

5

Re-connect the battery terminal and test the unit for proper operation. Mount the head uni t/kit assembly to the sub-dash with (4) Phillips screws previously removed in step #1.

2