2004-2010 MITSUBISHI ENDEAVOR
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2Unsnap and remove entire panel sur- rounding radio and A/C controls.
(Figure A)
A
DA S H
3Remove (1) 10MM nut from the rear support
| on the top left of radio on cross bar behind | B |
| dash. (FIGURE B) | |
4 | Remove (3) Phillips screws to remove |
|
| factory radio chassis (Figure C) |
|
5 | Remove (4) Phillips screws from the pock- | C |
| et at the bottom of the radio and A/C panel |
and remove the pocket. (This is where the
D
DI S A S S E M B LY
1