Audio Wiring, Fig. a | Metra Electronics 99-5719 guide

99-5719 KIT PREPARATION

FORD TAURUS 2004- 2007

1	Remove the In-Car temp	A 2	Fig. A	Back
	sensor housing from the			wall
	sensor housing from the

99-5719

FORD TAURUS 2004- 2007

AUDIO WIRING

back of the factory control
panel. Insert into the includ-	Inside edge	Back
	of sub-dash	Back
	of sub-dash	wall
ed In-Car temp sensor		wall
		Fig. B

housing and mount the		Inside edge
		of sub-dash

assembly under the dash.
2 Remove the factory rear sup-
port in the sub-dash. (Fig. A)

Continue to Kit Assembly

Open the trunk, remove (4) pop- clips from the driver’s side trunk liner and remove the liner. (see Fig. A) ocate the factory tuner on the wall of the trunk and discon- nect the speaker and antenna plugs (it is NOT necessary to remove the tuner). (see Fig. B). Plug the

70-5715 into the unit speaker plug and the antenna extension lead into the unit antenna plug. Slide the ex- tension harness through the space in the back seat between the seat back and seat bottom. Unclip the rocker trim, tuck the extension har- ness under the carpet and stretch the harness to the back of the dash. (Replace the rocker trim when completed). Splice the speaker leads on the extension harness into the rear of the aftermarket head unit. Plug the factory wiringhar- nesses into the switch connectors (previously mounted in step #2) and audio connectors on the back of the Integrated Mounting Kit.

Fig. A

(located under
the rear deck)	Fig. B
	Fig. B