Velodyne Acoustics SC-600D, SC-600 IW, SC-600 IF/IC user manual U t i o n

Page 2

C a u t i o n !

Caution

To reduce the risk of electric shock, do not remove cover (or back). No user-serviceable parts inside. Refer servicing to qualified service personnel.

The lightning flash with arrowhead symbol is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the subwoofer.

1.Read Instructions — All safety and operating instructions should be read before the product is operated.

2.Retain Instructions — The safety and operating instructions should be retained for future reference.

3.Heed Warnings — All warnings on the product and in the operating instructions should be adhered to.

4.Follow Instructions — All operating and use instructions should be followed.

5.Water and Moisture — The product should not be used near water — for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, near a swimming pool or the like.

6.Carts and Stands — The product should be used only with a cart or stand recommended by the manufacturer. If a cart is used, use caution when moving the cart/product to avoid injury from tip-over.

7.Wall or Ceiling Mounting — The product should be mounted to a wall or ceiling only as recommended by the manufacturer.

8.Ventilation — The product should be situated so that its location or position does not interfere with its proper ventilation. For example, the product should not be situated on a bed, sofa, rug, or similar surface that may block the ventilation openings; or placed in a built-in installation such as a bookcase or cabinet that may impede the flow of air through the ventilation openings. The ventilation shall not be impeded by covering the ventilation openings with items such as newspapers, tablecloths, curtains, etc.

9.Heat — The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat.

10.Flame — Keep the product away from open flame sources.

11.Power Sources — The product should be connected to a power supply only of the type described in the operating instructions or as marked on the product.

12.Grounding or Polarization — This product may be equipped with a polarized alternating-current line plug (a plug having one blade wider than the other). (A grounding type plug has two blades and a third grounding prong.) This plug will fit into the power outlet only one way. This is a safety feature. If you are unable to insert the plug fully into the outlet, try reversing the plug. If the plug should still fail to fit, contact your electrician to replace your obsolete outlet. Do not defeat the safety purpose of the polarized plug.

13.Power-Cord Protection — Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point at which they exit from the product.

14.Cleaning — The product should be cleaned only as recommended by the manufacturer.

15.Nonuse Periods — The power cord of the product should be unplugged from the outlet when left unused for a long period of time.

16.Object and Liquid Entry — Care should be taken so that objects do not fall and liquids are not spilled onto the enclosure.

17.Damage Requiring Service — The product should be serviced by qualified service personnel when:

a.The power-supply cord or plug has been damaged.

b.Objects have fallen or liquid has been spilled into the product.

c.The product has been exposed to rain or moisture.

d.The product does not appear to operate normally or exhibits a marked change in performance.

e.The product has been dropped or damaged.

18.Servicing — The user should not attempt to service the product beyond what is described in the operating instructions. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as a power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

19.Lightning — For added protection for the product during a lightning storm or when it is left unattended and unused for long periods of time, unplug it from the wall outlet.

20.Overloading — Do not overload wall outlets, extension cords or integral convenience receptacles as this can result in a risk of fire or electric shock.

21.Attachments — Only use attachments and accessories specified by the manufacturer.

22.Voltage — Insure that the subwoofer is only connected to the rated source voltage. Do not connect the 120-volt version to 230-volts or vice-versa. This will result in damage to the subwoofer and possible injury to the user.

23.Climates — This product can be used in tropical or moderate climates.

CAutION: To prevent electrical shock, match wide blade of plug to wide slot, fully inserted.

WARNING: To reduce the risk of fire or electrical shock, do not expose this product to rain or moisture.

w w w . v e l o d y n e . c o m

SC-600D Amplifier User’s Manual

i

Page 1 Page 3
Image 2
Page 1 Page 3
Contents SC-600D Amplifier U t i o n Table of Contents N g r a t u l a t i o n s Product FeaturesPrior to Installation SC 600D Subwoofer AmplifierSC-600 IW In-Wall Setup ChecklistSC 600 IW, SC 600 IF/IC Subwoofers SC-600 IF/IC In-Floor/In-CeilingS ta l l a t i o n Front Panel Controls and DisplaysRear Panel Connections Mono LFE Line-Level Connection 12 12V Trigger Signal Sensing Auto On/Off SwitchIR Input 13 RS-232Subwoofer Connection 5-Way Binding Post Terminals Power Cord AdapterMain Power Switch FuseAbout LOW Pass Crossovers Disabling the Low Pass Cr ossover Subwoofer Dir ectWord about Subwoofer Placement Word about Interconnect CablesSelecting the Subwoofer to be Controlled Model LED DisplayA ge Remote Contr olSC-600D Amplifier User’s Manual Musical Style Suggested Preset Restoring Defaults Care of your Amplifier and SubwooferTroubleshooting and Service Thank You for Purchasing an SC-600D AmplifierSpecification s Specifications SC-600D Subwoofer AmplifierSC in and OUT Por t Pin Configuration Appendix a RS-232 Serial Overview and CommandsCom Por t Setup Runtime Command FormatSC-600D Amplifier User’s Manual Register. . . on Line . . . It’s faster . . . and easier Velodyne Acoustics, Inc
Related manuals
Manual 13 pages 33.3 Kb Manual 2 pages 26.34 Kb Manual 2 pages 29.69 Kb

SC-600D, SC-600 IF/IC, SC-600 IW specifications

Velodyne Acoustics has long been synonymous with high-quality audio and innovative sound technology, and its latest offerings, the SC-600 IF/IC, SC-600 IW, and SC-600D speakers, further solidify this reputation. Designed to deliver immersive sound experiences across various listening environments, these speakers incorporate cutting-edge innovations that cater to both audiophiles and casual listeners alike.

The SC-600 IF/IC model is specifically engineered for in-ceiling applications. It boasts a 6.5-inch woven fiberglass woofer, which allows for deep, rich bass reproduction. Coupled with a 1-inch aluminum dome tweeter, the speaker delivers a balanced frequency response that highlights both highs and lows. The speaker's unique insulation ensures minimal sound leakage, providing an immersive home theater experience without disturbing adjacent rooms.

On the other hand, the SC-600 IW is designed for in-wall installations. Its slim profile means it can seamlessly integrate into any home decor while still producing exceptional sound clarity. The 6.5-inch woofer is specifically designed to reproduce rigorous sound dynamics, enhancing music and movie experiences. The SC-600 IW also features a high-performance crossover network, ensuring that the transition between the woofer and tweeter is smooth and natural. This model is ideal for those looking for a discreet audio solution without sacrificing sound quality.

Lastly, the SC-600D serves as the standout option in the lineup with its dual 6.5-inch woofers. This model is capable of delivering deeper bass and heightened volume levels, making it perfect for larger spaces or dedicated home theaters. With advanced digital signal processing, the SC-600D can adapt to various acoustic environments, ensuring optimal performance regardless of placement. Its robust construction also minimizes distortion, allowing for clarity and precision in playback.

All three models employ Velodyne's proprietary technologies, including high-efficiency drivers and advanced acoustic engineering, to ensure that they deliver an unparalleled listening experience. Furthermore, the easy-to-install design of these speakers caters to both DIY enthusiasts and professional installers, making them versatile options for any audio project.

In summary, the Velodyne Acoustics SC-600 series combines aesthetic appeal with top-notch technology. Whether for home theaters, music rooms, or whole-home audio solutions, these speakers promise to enhance the overall audio experience by marrying design with exceptional sound performance. The SC-600 IF/IC, SC-600 IW, and SC-600D represent the pinnacle of modern speaker design and sound engineering, catering to the diverse needs of audio enthusiasts everywhere.
Top Page Image Contents