Soundstream Technologies 502, 1002, 702 owner manual Installation Step, Wiring

( INSTALLATION STEP 3 ]

WIRING

POWER AND GROUND

To ensure maximum output from your RUBICON amplifier, use high quality, low- loss power and ground cables and connections. The RUBICON amplifiers will accept up to 4 gauge power and ground cables. Determine from the chart below the minimum gauge power and ground wire for your application.

I		I	up to 10’		I		up to 20’	I
	RUBICON 502		4 or 8	gauge		4	gauge only
	RUB/CON	702	4 or 8	gauge		4	gauge only
	RUB/CON	1002	4 gauge only			4	gauge only

CIRCUIT BREAKERS AND FUSES

EXTERNAL

Like all audio components, the RUBICON amplifiers must be fused near the battery. A fuse or circuit breaker must be located within 18” of the batterv. This will

prevent a fire in the event of a shorted cable. See the chart below to determine the correct fuse value.

INTERNAL

The RUBICON amplifiers are fused with an automotive-type or Maxi-fuse. In the event of a blown power supply fuse(s), replace with the correct value fuse found in the chart below. Never replace the fuse with a higher value than what is sup- plied. This may result in amplifier damage and will void the warranty1

RUB/CON Amplifier Fuse Values

I		I	Amplifier Fuse	I	Battery Fuse / Circuit Breaker
	RUBICON 502	I	(2) 30 amp automotive	I	80 amp
I	RUB/CON 702	I	60 amp Maxi-fuse	T	-1
					80 amp
1	RUB/CON 1002 1		80 amp Maxi-fuse		100 amp

REMOTE TURN-ON

Connect the “Remote” line to the turn-on lead from the source unit. When+12 Volts is received, the amplifier will turn on.

SIGNAL CABLE

Use a high quality cable that will be easy to install and has minimal signal loss to guarantee optimum performance.

SPEAKER CABLE

The RUBICON amplifiers will accept up to 8 gauge speaker cable. Use a high quality, flexible, multi-strand cable for best performance and longevity.

I ’ [Head Unit iw 1

To Chassis	To 2nd
	Amplifier
Ground
	I_ (optIona<)

Fuse	1
at the
Battery
	”

SPEAKERS

To +lZV

+I-Battery

Terminal

14 15