RS-10 subwoofer

RS10 Brochure 12/09/05 9:58 AM Page 8

Good bass requires the ability to move large volumes of air with extreme precision. This demands a significant amount of power and dynamic headroom. The RS10 subwoofer is designed with plenty of power to spare.

A Class AB amplifier has been specifically designed for this model. Very low distortion, exceptional headroom, and a high internal electrical damping factor of the strong, fast KEVLAR cone provides accurate control, for performance well above the specification.

Power is nothing without control, however. The RS-10 subwoofer uses an advanced microprocessor controlled analogue low-pass filter section for sonic performance with a low noise floor. By minimising frequency overlap, fourth order, 24dB/ octave filter slopes, ensure clean integration with full range systems in a wide range of applications.

Low-pass frequencies are adjustable across six settings in 10Hz steps from 35-85Hz.

Where a high quality A/V processor controls the subwoofer signal, it is also possible to switch all filters off, or use a combination of both.

In subwoofers of this quality, end users demand the best performance possible from their home cinema system, and also from their stereo music collection.

With its flexibility and sophisticated control section, the RS-10 sub provides four memory settings which can be used to store all of the calibration information for a range of uses, and these can be recalled at the press of a button.

The full function remote control supplied with the RS-10 sub provides the most user-friendly interface for set-up and adjustment.

Users can, with the display on the subwoofer, set up the full system from the actual listening position and adjust the settings easily without having to move furniture or otherwise access the rear panel.