Atlas Sound specifications AL-DOCK Description, AL2430-2PH Function Description

Owner’s Manual	AL2430-2PH	Wireless Infrared Classroom
		Sound Reinforcement System

AL-DOCK Description

40.Microphone Charging Receptacles

Holds the Microphones in place while charging.

The microphones can be placed in forwards or backwards.

41.Microphone Charging LEDs

These LEDs indicate the current charging status of each receptacle: Red = Charging,

Green = Charged.

42.Battery Cover

This provides a charging location for four additional AA size batteries.

43.Additional Battery Charging LEDs

These two LEDs indicate the current charging status of the additional battery charging locations:

RED = Charging GREEN = Charged.

AL2430-2PH Function Description

40

43 42

The versatile AL-PH Microphone performs the functions of a wireless microphone and a system remote control. It can be used as a Handheld Microphone, a Lapel Microhone with included Lanyard(AL-LANYARD), or a Belt Pack Microphone with optional AL-HSM headset. Each AL-PH has a switch located under the battery door used to set its IR Channel to either A or B. One AL-PH must be set to Channel A and the other AL-PH must be set to Channel B. The system will not function properly if there are two AL-PHs set to the same IR channel.

Also located under the battery door is the LOCKOUT switch. When this is engaged all function buttons are disabled and the unit can be used as a microphone only.

The AL-PH can be set in two different modes that effect the control it has over the AL2430 system.

Mode 1:

•The right side blue LED will be illuminated

•Volume UP / DOWN buttons will control the microphone volume

•The Mute button mutes the microphone

Mode 2:

•Both blue LEDs will be illuminated

•Volume UP / DOWN buttons will control the multimedia inputs on the AL2430 Receiver / Amplifier

•Mute button will mute the multimedia inputs on the AL2430 Receiver / Amplifier

Power and Panic buttons function as described below regardless of microphones mode setting.

The Power button needs to be pressed for three seconds to turn the unit on or off.

When the Panic button is pressed along with the Mode button, a signal is sent to the AL2430 Receiver / Amplifier. This closes its Panic Output relay. The Panic Output relay can be connected to an external system. For example: the school's Paging / Intercom system to alert someone of an event in the class room that requires immediate attention.

1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.

Telephone: 800.876.3333 • Fax: 800.765.3435

– 9 – AtlasSound.com

Specifications are subject to change without notice.