Setup Procedure | JBL MS-2 guide

DISTRACTION WARNING: Do NOT perform the setup procedure while driving. We recommend that you perform these functions only after pulling off the road into a position that you are absolutely sure presents no risk. Always obey all traffic laws while driving.

Setup Procedure:

1.Connect the MS-2 as shown in the Connections section on page 2.

2.Enable your vehicle audio system’s “Aux” (or MP3) input.

3.Set your portable audio player’s volume level to 3/4 full or higher and play music on it. The MS-2’s input indicator should light green. If the input indicator flashes red, turn the volume of your portable player down until the red light stops flashing and remember the setting. This is the volume control setting you should use on your portable player while using the MS-2.

	Set player	Input LED flashes.
	volume at 3/4.	Input LED flashes.
	volume at 3/4.

6" – 8"

(150mm – 200mm)

6.Press and hold the Setup button. The Setup indicators will flash one at a time and you will hear brief test signals through your audio system’s speakers. IMPORTANT: Do not move the MS-2 while the test signals are playing.

7.Keep holding the Setup button until one of the three Setup indicators remains lit, showing the setup results:

4. Adjust your vehicle audio system’s volume control so the music is playing

at a comfortable volume level. Adjust the front/rear fader control so that

the sound comes mostly from the front speakers but so you can still hear

Press-Setup

and-holdLEDs

Setupflash

button

•OK: Setup has been completed successfully.

The MS-2’s DSP equalization and time correction processing is now active.

•High: Your vehicle audio system’s volume control was set too high during the setup procedure. Lower the system’s volume and repeat steps 5 – 7.

•Low: Your vehicle audio system’s volume control was set too low during the setup procedure. Raise the system’s volume and repeat steps 5 – 7.

some sound from the back. You can readjust this after setup.

5. As you sit in your vehicle’s driver’s seat, hold the MS-2 directly in front of

your face, about 6 – 8 inches (150mm – 200mm) away.

You can repeat the setup procedure at any time. For example, if you want to re-tune the system for a different listening position, simply repeat steps 5 – 7 while sitting in the new location. If you want to use the MS-2 in a different vehicle, you will need to repeat the entire setup procedure (steps 1 – 7).