JBL PB10 specifications Preamp line- level output

Dolby Pro Logic (Non-Digital) – Line Level

Dolby Digital or DTS (or Other Digital Surround Mode) Connection

Use this installation method	use the “LFE” position with
for Dolby Pro Logic appli-	Dolby Pro Logic-only
cations (not Dolby Digital, DTS	processors.
or other digital processing),	Note: If your receiver or
where the receiver/processor
	amplifier only has one
is equipped with a subwoofer
	subwoofer output jack,
output or a volume-controlled
	then you may connect the
preamp (line-) level output:
	subwoofer output on your
Use RCA-type patch cords	receiver/preamplifier to either
to connect the line-level	the left or right line-level input
subwoofer outputs on your	on the subwoofer. It makes no
receiver or amplifier to the	difference which jack you
line-level inputs on the	choose.
subwoofer. IMPORTANT:	Connect each speaker to the
Make sure that the LFE toggle
	corresponding speaker
switch on the subwoofer is in
	terminals on your receiver or
the “Normal” position. Do not
	amplifier.
	LEVEL
	Min	Max
	LFE	NORMAL
	PHASE 0º	180º
	CROSSOVER
	FREQUENCY

Make sure your receiver or processor is configured cor- rectly: Make sure that the sub- woofer is configured as “On.”

Note for advanced users: If your receiver/processor has a built-in low-pass crossover filter for the subwoofer output, then the LFE switch should be set to the “LFE” position to bypass the subwoofer’s internal crossover.

Use this installation method	then you may connect the	center and rear speakers
for Dolby Digital, DTS or other	subwoofer output on your	should be set to “Small” or
digital surround processors:	receiver/preamplifier to either	“Large” depending on their
IMPORTANT: Make sure that	the left or right line-level input	size and frequency response.
the LFE toggle switch on the	on the subwoofer. It makes no	Consult your receiver’s or
	difference which jack you	processor’s owner’s manual.
subwoofer is in the “LFE”
	choose.
position. Use the line-level
input jacks for the Low-	Connect each speaker to the
Frequency Effects channel.	corresponding speaker
Connect these jacks to the	terminals on your receiver or
LFE output or subwoofer	amplifier.
output on your receiver or	Make sure that you have
amplifier.
	configured your surround-
Note: If your receiver or
	sound processor for
amplifier only has one	“Subwoofer On” or “LFE On.”
subwoofer output jack,	The front left, front right,

LEVEL

MinMax

LFE NORMAL

PHASE 0º 180º

CROSSOVER

FREQUENCY

RECEIVER		50Hz	150Hz
Subwoofer
Out
L	R	L	R
		LINE LEVEL IN
		For LFE use L or R

RECEIVER/PREAMPLIFIER

Subwoofer

Output/LFE

LINE LEVEL IN

50Hz150Hz

L R

For LFE use L or R

L

HIGH

LEVEL

IN

R

+ –

L

HIGH

LEVEL

OUT

R

4

L

HIGH

LEVEL

IN

R

+ –

L

HIGH

LEVEL

OUT

R

5