®
Wiring
Power and Outputs
FUSE
| + 12V RMT GND |
25A | 25A |
POWER 
XA4150
+ | – | + | |
| SPEAKER |
| |
Power Terminal (BATT +12V)
Connect directly to the vehicle battery+ terminal with 8 gauge wire (minimum).
+ 12V RMT GND
Remote Terminal (RMT +12V)
Connect the radio power antenna lead from the receiver to the amplifier remote (RMT) terminal. This turns the amplifier on whenever the receiver is turned on. If a power antenna lead is not available, connect this wire to the radio or accessory fuse.
Not Supplied
50 amp Fuse |
or Circuit Breaker |
Spade
Connector
8 Gauge
+ 12V | RMT | GND |
Spade
Battery
Terminal
Adapter
Install as close |
to the battery |
as possible |
To Battery+
Terminal
Wire
ButtConnector Connector
(not supplied)
8 Gauge
To Receiver
Power
Wire
Ground Terminal (GND)
Connect to a good chassis ground. The ground connection should be to clean, unpainted metal to provide a good electrical connection.
+ 12V | RMT | GND |
|
| Spade |
| Sheet Metal | Connector |
Ring | Screw |
|
(supplied) |
| |
Connector |
| |
|
| |
|
| 8 Gauge |
|
| Wire |
Drill 1/8" hole |
|
|
in chassis |
|
|
sheet metal |
|
|
4
Antenna Lead
Fuses
FUSE
Use only two 25 amp
25A
5314Eamp.p65 | 4 | 4/10/99, 7:08 PM |