Indicators and Controls, Crossover X-OVER

A400HLX, A600HLX

Indicators and Controls

HPF

FULL	BASS		L-CHX			R-CHX		LEVEL
LPF	3	5	60	125	60	125	2	4

FRONT

REAR

POWER

PROTECT

2CH

3CH

4CH

MODE

0dB

12dB

40Hz

400Hz

40Hz

400Hz

.3V

Adjust the crossover to accommodate your					Tri-mode/Three channel operation
Adjust the crossover to accommodate your					Tri-mode/Three channel operation
chosen installation method.
			•	LPF–(low pass filter) Select	An amplifier is usually configured for tri-mode
			•	LPF–(low pass filter) Select	operation when you want to use one amplifier to
				this filter when the amplifier will	operation when you want to use one amplifier to
		LPF		this filter when the amplifier will	drive a pair of front speakers and subwoofer(s).
		FULL		be driving woofers or	In other words, when you want drive a complete
		FULL		subwoofers.	In other words, when you want drive a complete
		HPF		subwoofers.	system with one amp. Your Jensen amplifier is
	FRONT		• FULL–Crossover is not active,		capable of tri-mode operation.
			• FULL–Crossover is not active,		capable of tri-mode operation.
	REAR			amplifier is in “full range”	Important
	REAR			mode.	Important
		LPF		mode.	Tri-mode operation requires using “passive
		LPF			Tri-mode operation requires using “passive
		FULL	•	HPF–(high pass filter) Select	crossovers”. These crossovers are available at
		HPF		this filter when the amplifier will	your local retailer or install shop. Failure to
				this filter when the amplifier will	your local retailer or install shop. Failure to
				be driving full range/separate	install these filters may damage your amplifier
				speakers, and you want to limit	and/or your speakers.
				the “bass” going to these	See page 9.
				speakers.	See page 9.
				speakers.

POWER

PROTECT

A dual status LED indicator illuminates red or green to indicate the status of the amplifier.

Green – Power applied, ON

Red – Protection circuit activated, STANDBY

REC002_A4n600HLX_E

1/9/02, 4:13 PM