*Read the next three steps to fully understand this procedure.*
S T E P 4
Place the Stealthbox® into the mounting location and press firmly onto the Stealthbox®.
S T E P 4 A
The Stealthbox® needs to fit all the way to top plastic panel.
S T E P 4 B
The Stealthbox® will be raised off the floor. This is to allow the factory flooring to be pulled from the cargo area, once the Stealthbox® is installed.
S T E P 5
Note: Before drilling, you are drilling into the rear fender well. Once you protrude to the outside, do not go any further or you will be paying for a new rear tire. Always wear eye protection when drilling!
With a drill and a
Remove the wax square.
SB-VW-GTI/10W6v2_INSTR_SKU#011250
S T E P 6
Run speaker wire from the amplifier’s location to the Stealthbox® location and check for proper operation of the woofer.
S T E P 7
Place the Stealthbox® into the mounting location. Guide the socket cup set screw through the drilled hole.
S T E P 8
Jack up the driver’s side rear of the vehicle.
You should be able to access the socket cup set screw with the rear wheel on the car. If necessary, you may remove the wheel off the car.
S T E P 9
Behind the strut, pull the black plastic guard to gain access to the protruding socket cup set screw.
Page 2 • JL Audio, Inc 2007 | Continued on Next Page |