S T E P 4
The top cut line runs straight across. The line does not follow the corner crease, as like the other cut lines. This top line is
S T E P 5
Remove the ribs that are located on the back side of the storage bin.
S T E P 6
The Stealthbox® is to be inserted from the back side of the modified panel. If necessary, trim the panel to allow the Stealthbox® to fit.
S T E P 8
Thread the supplied socket cup screw into the rear of the Stealthbox®, leaving
Place the Stealthbox® with the modified plastic panel into the mounting location and press firmly onto the Stealthbox®.
Remove the Stealthbox® with the plastic panel carefully, leaving the wax square in place. The socket cup set screw will leave an impression onto the wax square.
S T E P 9
Note: Before drilling, make sure that you are not going to be drilling into any gas lines, brake lines, transmission lines, electrical wiring, transfer case (4x4 vehicles) or anything else that might cause a reduc- tion in your weekly pay. Always wear eye protection when drilling!
With a drill and a
Remove the wax square.
S T E P 1 0
Back out the socket cup set screw that was installed in STEP 8, to expose 1
Place the Stealthbox® with the plastic panel back into the mount area. Guide the socket cup set screw through the drilled hole.
Run speaker wire from the amplifier’s location to the Stealthbox® location and check for proper operation of the woofer.
(1)
(2)
S T E P 7
The supplied wax square is to be placed onto the rear wall, just to the right of the second mount as in the picture.
STEALTHBOX WALL |
VEHICLE SHEET METAL |
LOCK WASHER |
HEX NUT |
SOCKET CUP SET SCREW |
FLAT WASHER |
THREADED INSERT |
FENDER WASHER |
S T E P 1 1
From under the vehicle, place the supplied fender washers, flat washers, lock washers and then hex nut onto the protruding socket cup set screw and secure. Adjust the amount of exposed thread on each cup set screw if necessary.
Note: For added protection, it is recommended that you apply a bead of silicone between the vehicle and the fender washer. After the bolt assembly is tightly secured, it is also recommended that vehicle under- coating material is applied to the exposed assembly.
Page 2 • JL Audio, Inc 2007 | Continued on Next Page |