S T E P 3
Place the Stealthbox® into the vehicle in the orientation that it will ultimately remain in. The speaker terminals should be on the side facing towards the front of the vehicle. Once in place, press down on the enclosure so that the two
S T E P 4
*CAUTION*
Before drilling, always make sure that you are not going to be drilling into any gas lines, brake lines, transmission lines, electrical wiring, exhaust systems
or anything else that might cause a reduction in your weekly pay. Always wear eye protection when drilling.
Using a 1/2” drill bit, drill where the impressions were made in the wax squares.
I N C L U D E D H A R D W A R E
2) | 3/8” Flat Washer | 2) | 3/8” Split Lock Washer |
2) | 2) | 3/8” Hex Nut |
S P E C I F I C A T I O N S
Enclosure Type: Acoustic Suspension (sealed)
Driver Type: 8W7 (2)
Nominal Impedance: 3 Ohm (each)
Continuous Power Handling: 500 Watts (each)
P o w e r R e c o m m e n d a t i o n
JL Audio recommends using a high quality amplifier such as the JL Audio HD750/1.
The diagram below shows the recommended crossover, infrasonic filter and equalizer settings for the HD750/1 when being used to power your Stealthbox®.
STEALTHBOX WALL | THREADED INSERT |
| |
| VEHICLE SHEET METAL |
FENDER WASHER | SOCKET CUP SET SCREW |
| |
FLAT WASHER |
|
LOCK WASHER |
|
HEX BOLT |
|
S T E P 5
Set the enclosure into place with the Socket Cup Set Screw going through the holes drilled in STEP 4. Install the supplied hardware on the Socket Cup Set Screw to secure the Stealthbox®. There should be a Hex Head Nut, Split Lock Washer and, Flat Washer on each Socket Cup Set Screw. Only snug each set of hardware initially then, tighten each set after they are both snug.
D e t a i l
C O N G R A T U L A T I O N S !
You have completed the installation for this model!
Enjoy your new Stealthbox®!
Please refer to the Power Recommendation section for an amplifier recommendation and basic
The JL Audio HD750/1 is a very versatile audio component. Please consult the owner’s manual for even more detailed information about installing and tuning this amplifier.
M I D / H I G H F r e q u e n c y D r i v e r F I T M E N T
A variety of JL Audio coaxial and component systems will fit in the factory speaker locations of your vehicle.
Front Speaker Size / Location: 6 1/2”- Front Doors
Fits JL Audio Models:
Rear Speaker Size / Location: 6inch x 9inch - Rear sides
Fits JL Audio Models:
*Smaller speakers would also fit using custom adaptors
(954) |
| www.jlaudio.com |
|
|
| |
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered |
|
|
|
| ||
trademarks of JL Audio, Inc. “Ahead of the Curve” and its respective logo is a trademark of JL Audio, Inc. |
|
|
|
| ||
|
|
|
| |||
#6,243,479 #6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign |
|
|
|
| ||
patents pending. For more detailed information please visit us online at www.jlaudio.com. |
|
|
|
|
|
|
1 0 3 6 9 N O R T H C O M M E R C E P A R K W A Y | • | M I R A M A R , F L O R I D A | • | 3 3 0 2 5 | • | U S A |
Page 2 • JL Audio, Inc 2008