S T E P 4
The “hooked end” of each of the Custom Brackets hooks onto the bottom edge of the plastic trim along the front of the hatch area of the car as shown.
S T E P 5
Once the brackets are installed, align them with the factory installed threaded bosses as indicated.
S T E P 6
Secure the Custom Brackets with the supplied Hex Head Bolt, Split Lock Washer and Flat Washer, tighten all fasteners.
S t e p 7
Install Allen Head Stud into Speed Nut installed in STEP 3
S T E P 8
With both Allen Head Studs installed, put the carpet for the rear area back into the car.
S T E P 9
Locate the two studs by pressing down on the carpet while making sure that carpet remains centered.
S T E P 1 0
Make two small “x” cuts where the Allen Head Studs are so that they will come up through the carpet.
S T E P 1 1
With the woofers removed, install the Stealthbox®, having the Allen Head Studs come up through the bottom of the enclosure.
Page 2 • JL Audio, Inc 2009 | Continued on Next Page |