S T E P 4
Slide enclosure into place and press against the inner fender, producing indentations in the wax squares where the studs hit. Remove the enclosure.
S T E P 5
Notice the Inner Fender Liner Fasteners, all 12 of these fasten- ers need to be removed so that the Inner Fender Liner can be dropped down on the rear tire. This needs to be done so that you can gain access to the Hole where the Allen Head Stud will come through the Inner Fender.
S T E P 7
Start the included hardware on the
S T E P 8
Reaching down and around through the hole where the taillight mounts, you will find the rear Allen Head Stud. Install included hardware as illustrated above.
D e t a i l
Pulling on the center head of the inner fender body fasteners will allow the fastener to be removed.
STEALTHBOX WALL |
|
| CARPETING |
| LOCK WASHER |
| ALLEN HEAD STUD |
| HEX NUT |
THREADED INSERT | FLAT WASHER |
| |
| VEHICLE SHEET METAL |
S T E P 9
Once the hardware is started on BOTH the front, and rear Allen Head Studs, you can tighten the hardware down.
Page 2 • JL Audio, Inc 2008
S T E P 6
At each mark in the wax squares, drill a 3/8” hole through the carpeting and inner fender. Back out the Allen Head Studs in the Stealthbox® so that Approximately 1” is exposed.
*CAUTION*
Before drilling, always make sure that you are not going to be drilling into any gas lines, brake lines, transmission lines, electrical wiring, exhaust systems or anything else that might cause a reduction in your weekly pay. Always wear eye protection when drilling.
S T E P 1 0
C O N G R A T U L A T I O N S !
You have completed the installation for this model!
Enjoy your new Stealthbox®!
Please refer to the Power Recommendation section for an amplifier recommendation and basic
Continued on Next Page