S T E P 1 2
Remove backing from wax square and place it on sheet metal just below tail light wiring as shown.
S T E P 1 6
Put Stealthbox® into final position with mounting stud extended through hole drilled in tail light area. Secure with nut, lock washer, and flat washer provided (see illustration).
S T E P 1 3
Place Stealthbox® into location as shown, push stud against wax square to make an impression in the wax square.
STEALTHBOX WALL |
VEHICLE SHEET METAL |
LOCK WASHER |
HEX NUT |
SOCKET CUP SET SCREW |
FLAT WASHER |
THREADED INSERT |
FENDER WASHER |
S T E P 1 7
Position the Stealthbox® into the mounting location. From the outside of the vehicle (behind the taillight) place the sup- plied fender washer, flat washer, lock washer and then nut onto the exposed socket cup set screw. Use a long 3/8" open end wrench or ratcheting box end to secure the mounting hardware. Be sure Stealthbox is now solidly mounted to vehicle.
Note: For added weather protection, it is recommended that you apply a bead of silicone between the vehicle and the fender washer.
S T E P 1 4
Remove Stealthbox®. Drill 1/2 inch diameter hole through wax square and sheet metal at stud impression.
Remove the wax square.
it is recommended that vehicle undercoating be applied where the mounting hole was drilled.
S T E P 1 5
Extend mounting stud 1 1/2 inch from enclosure.
S T E P 1 8
Connect the previously run wire to the Stealthbox® and test the system to ensure that everything sounds good so far.
S T E P 1 9
Reinstall taillight in reverse oder of removal as detailed in steps 9,8. Make sure that bulbs go into the right locations in the lens assembly by checking the brake lights, running lights and, reverse lights. Be carefull of alignment of pins as lens assembly is reinserted into fender recess. Secure mount- ing with the factory 8mm screws.
Page 3 • JL Audio, Inc 2008 | Continued on Next Page |