S T E P 4
Remove the interior plastic trim panel, you can leave the sections of the panel that the seatbelts go through as shown.
S T E P 5
Remove the OEM subwoofer/amplifier as shown. Run the wire for the Stealthbox® to this general location (indicated by arrow) as the Stealthbox® will be mounted here, leave extra wire so that you can secure it as desired once the installation is finished.
S T E P 6
The factory subwoofer grille (as shown) needs to be removed, this process will be completed namely from the back side of the panel.
S T E P 7
Using a Die grinder (or a Dremel® type tool), grind off all of the plastic welds as shown.
***CAUTION***
Always follow proper safety techniques when using power tools as described by the tool manufacturer.
3/8”
1”
S T E P 8
This is the back of the grille completely removed showing all of the welds that needed to be removed.
S T E P 9
Looking at the panel from the front, trim all of the edges of the opening so that on the sides and bottom, there is a flange inside the recess where the grille was that is 1” wide and at the top, the flange should be approximately 3/8” wide as shown.
S T E P 1 0
S T E P 1 1
Remove the woofer and, stuffing from the Stealthbox, slide the Stealthbox® into position, mark the two mounting holes as shown, remove the enclosure.
Page 2 • JL Audio, Inc 2009 | Continued on Next Page |