Marantz M-CR610 appendix Speaker connection, Connecting the speaker cables

Contents Connections Playback Settings Tips Appendix

Speaker connection

Here we connect the speakers in the room to this unit.

This section explains how to connect them using typical examples.

NOTE

•Disconnect this unit’s power plug from the power outlet before connecting the speakers. Also, turn off the subwoofer.

•Connect so that the speaker cable core wires do not protrude from the speaker terminal. The protection circuit may be activated if the core wires touch the rear panel or if the + and – sides touch each other (vpage 112 “Protection circuit”).

•Never touch the speaker terminals while the power cord is connected. Doing so could result in electric shock.

•Use speakers with an impedance of 6 – 8 Ω/ohms. The protection circuit may be activated if speakers with an impedance other than specified are used.

Connecting the speaker cables

Carefully check the left (L) and right (R) channels and + (red) and – (black) polarities on the speakers being connected to this unit, and be sure to connect the channels and polarities correctly.

1 Peel off about 3/8 inch (10 mm) of sheathing from the tip of the speaker cable, then either twist the core wire tightly or terminate it.

2 Turnthespeakerterminalcounterclockwise to loosen it.

3	Insert the speaker cable’s core wire to the
	hilt into the speaker terminal.

4 Turn the speaker terminal clockwise to tighten it.

			16
Front panel	Rear panel	Remote		Index