4Fixing the Anchors and Screws
Please follow the instructions.
- Check the wall material and thickness of the finish.
-You can use the anchors and screws provided with the TV for walls made with concrete, lightweight concrete, soft fieldstone, hard fieldstone, brick, or cellular blocks.
-Do not mount the device on walls made with plaster board or
-When installing it on a wall not specified in this manual, make sure each mounting position can withstand an load of 70 kgf (686 N) and a shearing load of 100 kgf (980 N) or more.
Anchor
a | b |
d |
|
|
|
|
|
| e |
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
c
Wall Mounting Screw
- Use Ф 8 mm drill bit for concrete and a hammer (impact) drill.
a. Drill a hole with a depth of
c. Insert the provided anchor into the hole. (Use a hammer when inserting the anchor.)
d. Place the wall mounting bracket close to the wall. Place the angle adjusting attachment facing upward. e. Insert the wall mounting screw into the hole and tighten it.
Tighten the screw using a recommended torque of 45 kgf/cm - 60 kgf/cm or more.
5Installing the Wall Mounting Supporter
Attach the screws
Wall mounting screw, 4 EA |
6 |
→Tighten the 4 wall mounting screws.
→If either of the mounting locations is inappropriate for installation, move both of the brackets to the locations that meet the conditions above.
→Fix the wall mounting supporter using the wall mounting screws as shown in the illustration.
→Tighten the screws until the wall, the wall mounting supporter, and the screws are joined together securely using a Phillips screwdriver (manual or drill) or 8 mm spanner.